Abbott ADC-90741 Disposable Pressure Sensor IBP Transducer Single Channel Instruction Manual

: June 25, 2024
: Abbott

Table of Contents

Abbott ADC-90741 Disposable Pressure Sensor IBP Transducer Single Channel
Help your sensor stay put.
Tips to keep your sensor secure.
ATHLETE OR HEAV Y EXERCISER?
Want extra stickiness?
Want extra stickiness?
The products below can increase your sensor’s staying power.¹ Check with

Abbott ADC-90741 Disposable Pressure Sensor IBP Transducer Single Channel

Instruction Manual

Help your sensor stay put.

Getting the most out of your wear time is as easy as 1, 2, 3:

Help your sensor stay put. Getting the most out of your wear time is as easy as 1, 2, 3:
PrepAfter washing, use an alcohol wipe to disinfect the site.Don’t apply body lotions or creams until the sensor is in place.
Dry Allow the skin to dry fully, which maximizes stickiness. This may require a little time, depending on the temperature and humidity of your environment.

PRO TIP: Complete these steps after showering for even better results.

Tips to keep your sensor secure.

Your sensor is designed to withstand the demands of everyday life. However, keeping a few things in mind can maximize wear time:

Always pat dry after showering or swimming¹ to avoid snagging the sensor on a towel.
Choose loose clothing² and take your time getting dressed so your sensor doesn’t get caught or pulled.
Resist the urge to play with your sensor and keep it away from curious hands, young and old alike.
Watch out for everyday obstacles like doorways, car doors, seat belts, and furniture edges.

ATHLETE OR HEAV Y EXERCISER?

Consider adding one of the extra adhesives on the following page and choose a site on the back of your upper arm that’s least likely for the sensor to get knocked oI.

Sensor is water-resistant in up to 1 meter (3 feet) of Do not immerse longer than 30 minutes.
The reader captures data from the sensor within 1cm to 4cm of the

Want extra stickiness?

The products below can increase your sensor’s staying power.¹ Check with your health care provider to see if they’re right for you.

Want extra stickiness?

The products below can increase your sensor’s staying power.¹ Check with

your health care provider to see if they’re right for you.

Tegaderm I.V.

3m.com A transparent film that provides adhesive strength

Skin-Prep Protective Wipes

smith- nephew.com An alcohol-free wipe that helps tape and films adhere to skin

Mastisol Liquid Adhesive

eloquesthealthcare.com

A clear, non-irritating liquid adhesive that secures dressings

Over-bandage

You can use medical-grade bandages or tape2 for extra security, but it must be applied at the time of sensor application and only removed when sensor wear is complete, since the sensor may come loose when peeling it oI.
Be sure to leave the opening/hole in the center of the sensor uncovered so it can breathe.

This list is not comprehensive and does not constitute an endorsement of the manufacturer or the product Abbott Diabetes Care is not responsible for the completeness or accuracy of product information. Product availability may vary by country and region. The manufacturer’s instructions for use of each product should be followed.
Additional medical grade bandages/tape can be applied, but do not remove bandages/tape once applied until sensor is ready for

The sensor housing, FreeStyle, Libre, and related brand marks are marks of Abbott. Other trademarks are the property of their respective owners.
©2024 Abbott. ADC-90741 v1.0