SKAR SK-BATT70AH AGM High Performance Car Audio Battery User Manual

SKAR SK-BATT70AH AGM High-Performance Car Audio Battery

Specifications

• Model: SK-BATT70AH
• Capacity: 70AH
• Charging Voltage: 14.4v maximum
• Terminal Tigh t ening Torque: 8 ft-lbs max

Product Usage Instructions

Charge Battery Before Initial Use

• Before installing, make sure to fully charge the battery using an AGM-specific charger that does not exceed 14.4v.

Do Not Over-Tighten Battery Terminals

• Ensure not to exceed 8 ft-lbs max torque when tightening terminals to avoid damage.

Installation Instructions

• Clear the designated location of any debris. Securely mount the battery to prevent falls. Connect leads to correct terminals (+ to +, – to -) and do not over-tighten.
• If using a dual battery setup, wire them in parallel for increased amperage output and reserve capacities.
• If using as a secondary battery, ensure proper grounding and fusing.

Charging Instructions

Use an AGM-specific charger with automatic shutoff to prevent over/under- charging. Charge before initial use and do not exceed 2.4 volts per cell during charging.

FAQ

Q: Can I use any charger to charge the Skar Audio AGM High-Performance Battery?

A: It is recommended to use an AGM-specific charger that does not exceed 14.4v to charge the battery safely.

Q: What should I do if I over-tighten the battery terminals?

A: If you over-tighten the terminals, it can strip out the bolt holes and render the battery useless. It is important to follow the specified torque limit of 8 ft-lbs.

CAUTION PLEASE READ BEFORE INSTALLING

INTRODUCTION

• We take immense pride in the quality and reliability of our products. Skar Audio AGM High-Performance Batteries are built to withstand even the most demanding conditions, ensuring that they will stand the test of time.
• Say goodbye to the inconvenience and frustration of battery failures, and welcome the peace of mind that comes with our exceptional batteries.

CHARGE BATTERY BEFORE INITIAL USE

• Before installing and wiring up your new Skar Audio AGM High-Performance Battery, you will want to ensure that the battery is fully charged.
• To do so you will need to connect your new Skar Audio AGM High Performance Battery to an AGM-specific charger that does not exceed 14.4v when charging.
• Once your AGM-specific charger has completed the charging cycle, you can now install your new Skar Audio AGM High-Performance Battery.

DO NOT OVER-TIGHTEN BATTERY TERMINALS

• Whether you are using the included automotive post adapters, bolts, or screws, do not exceed 8 ft-lbs max when tightening.
• Over-tightening can strip out the bolt holes and render your battery useless.

INSTALLATION INSTRUCTIONS

• Make sure that the designated battery location is clear of any debris or obstructions, as the presence of such materials could potentially result in sparking if the battery comes into contact with them.
• Once you have successfully placed your new battery in its installation location, securely mount the battery to ensure it cannot fall over.
• Skar Audio High-Performance Batteries are designed to be universal and will fit in most automotive, truck, and marine applications.
• Connect the battery leads to the correct terminals, (+) Positive lead to (+) Positive terminal / (-) Negative lead to (-) Negative terminal.
• Reminder: Do not tighten the terminal bolts, screws, or automotive post adapters more than 8 ft-lbs when connecting battery leads.
• If you are running a dual battery setup, ensure that the batteries are wired together in parallel which is (+) Positive to (+) Positive and (-) Negative to (-) Negative.
• Parallel will double the amperage output and reserve capacities. If you wire your batteries in series which is (+) Positive to (-) Negative you will double the voltage output of your Skar Audio AGM High Performance Batteries.
• If this battery is being used as a secondary battery, please ensure it is properly grounded to the chassis (no plastic or painted metal, must be bare metal) and proper fusing has been achieved.

CHARGING INSTRUCTIONS

• When charging your Skar Audio AGM High Performance
• Battery you will always want to use an AGM-specific charger that features an automatic shutoff to prevent over-charging or under-charging which could cause permanent damage to your battery.
• Charge your Skar Audio AGM High Performance Battery before initial use. This will ensure the battery will operate correctly once installed in your vehicle.
• Never allow your battery to charge above 2.4 volts per cell as this will cause the battery to “gas” and once the oxygen from the battery has vented, it cannot be restored.

LONG TERM VEHICLE STORAGE

• If your vehicle will be going into long-term storage you will want to follow the instructions below to prevent long-term damage to your Skar Audio AGM High-Performance Battery.
• Disconnect the battery from the main battery leads as well as any devices that will draw power.
• Do not leave a trickle charger on the battery as this will overcharge the battery.
• Use a battery tender device to ensure the battery stays at peak voltage while in storage.
• Test the voltage of your battery after it has been in storage. If it is below 12.6 Volts, you will need to charge the battery back to full with your AGM-specific charger before using it in your vehicle again.

WARNINGS & SAFETY PRECAUTIONS

• Never remove vent caps under the top label – this is a sealed battery.
• Prevent tools or other metal objects from falling across the battery terminals as this will short-circuit the battery and spark.
• Always wear protective clothing and eyewear when servicing a battery.
• Sulfuric acid can cause severe burns. If your skin comes in contact with acid, flush with water immediately.
• If acid goes into your eyes, flush with water immediately for 15 minutes and seek medical help as soon as possible.
• Keep any battery out of reach of children.

SPECIFICATIONS

SK-BATT70AH SPECIFICATIONS

CHARGING TIMES BASED ON USING A CURRENT TAPERING CHARGER SET AT 14.5 TO 15 VOLTS AND 100% RE-CHARGE

DANGER/POISON

• FLUSH EYES immediately with water and get medical help.
• STAND BACK Explosive gases can cause blindness or injury.
• SULFURIC ACID Will cause severe burns and possibly blindness.

PROP 65 WARNING:

• This product can expose you to chemicals including lead and lead compounds, which are known to the State of California to cause cancer birth defects, or other reproductive harm. Wash hands after handling.
• For more information, visit www.P65Warnings.ca.gov
• Skar Audio, Inc.WWW.SKARAUDIO.COM

References

• P65Warnings.ca.gov
• Skar Audio - Car Audio Subwoofers, Amplifiers, Speakers and more

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>