Qeridoo A-QSTI-23-BK Smart Tag Instruction Manual

Qeridoo A-QSTI-23-BK Smart Tag

Product Information

The Qeridoo Smart Tag is a device that helps you track and locate your items using the Find My app on your Apple devices. It is designed to be easy to use and set up, providing peace of mind for keeping track of your belongings.

Specifications:

• Article Number: A-QSTI-23-BK
• Nominal Voltage: 3 V
• Nominal Current: 175 mAh

Product Usage Instructions

1. Turn on the device:
   Remove the safety film from the battery compartment. Press and hold the button for 5 seconds until the device beeps and turns on.

2. Pair the device:
   Open the Find My app on your iPhone. Hold the device near the phone, tap on the “Items” tab, then tap on “+”, and select “Add Other Item”. Follow the on- screen instructions to connect and customize the settings for your device.

3. Activate Lost Mode:
   To activate Lost Mode, open the Find My app, tap on the “Items” tab, select your item, and then tap on “Enable” under Lost Mode. Follow the prompts to enter contact information and customize a lost message. Tap “Activate” to complete the setup.

4. Remove the device:
   To remove the device, open the Find My app, go to the “Items” tab, select your item, tap on “Remove Item”, and confirm by tapping on “Remove”.

FCC Warning:
This device complies with part 15 of the FCC Rules. Operation is subject to certain conditions to prevent interference. Any unauthorized changes may void the user’s authority to operate the equipment.

Qeridoo App

Turn on the device

Remove the safety film from the battery compartment. Press and hold the button for 5 seconds, the device beeps and turns on. Use the onboarding in the Qeridoo app to register the Smart Tag or use the following instructions.

Pair the device

Open the Find My App. Hold the device near the iPhone, tap on the „Items“ tab, on „+“ and then on „Add Other Item“. Tap on „Connect“ and select a name and an emoji for the device. Tap on „Agree“ to confirm that this item will be linked to the Apple ID. Tap on „Finish“.

Activate Lost Mode

Open the Find My App, tap on the „Items“ tab and then on your Item. Tap on „Enable“ under Lost Mode. Read the instructions, tap „Continue“ and enter a phone number or email address. Confirm the information, customize the lost message and tap „Activate“ to complete the setup.

Remove the device

Open the Find My App, tap on the „Items“ tab and then on your Item. Tap on „Remove Item“ and then on „Remove“ to complete the process.

Main Functions

1. Locate your Item
   If the missing device is not nearby, the Find My App can still help you find it. Other nearby devices in the Find My network will securely send the location of the missing device to iCloud so that the location is visible in the Find My App. The whole process is anonymous and encrypted to protect everyone‘s privacy.

2. Play Sound
   Open the Find My App, tap on the „Items“ tab and then on your item. Click on „Play Sound“ and the device will emit a tone.

3. Factory settings
   First, remove the device from the Find My App. Switch the device on and then press the device button twice. The device emits a signal tone. Press and hold the device button for 8 seconds until the device beeps again and the LED flashes three times. Release the button to complete the factory reset.

4. Power on
   Press the device button for 5 seconds. The device beeps, the LED flashes 3 times and the device switches on.

5. Power off
   When the device is switched on, press the device button 5 times within 2 seconds. The device beeps, the LED flashes 3 times and the device is switched off.

6. Device status confirmation
   Press the device button twice. If the device beeps and the LED flashes 3 times, the device is working. If there is no signal, the device is switched off.

Instructions for the use of batteries

NOTES ON THE DISPOSAL OF OLD ELECTRICAL AND ELECTRONIC DEVICES
The symbol shown on the left on the product, packaging or accompanying documents means that the product must be disposed of separately from household waste at the end of its life cycle. As a consumer, you are legally obliged to dispose of electrical or electronic products at a municipal collection point for waste electrical and electronic equipment. This is free of charge for you. Please remove the batteries before disposing of the product. Proper disposal enables the recycling of valuable raw materials and prevents possible negative effects on people and the environment. For more information, please contact your local authority or the seller of the product.

Rechargeable and non-rechargeable batteries must be disposed of in an environmentally friendly manner and are therefore marked with the adjacent symbol.

Technical Specifications

• Article number A-QSTI-23-BK
• Rated voltage 3 V
• Rated current -175 mAh

To use the Apple Find My app to locate Qeridoo Smart Tag, the latest version of iOS, iPadOS, or macOS is recommended. The Find Items app on Apple Watch requires the latest version of watchOS. Apple, Apple Find My, Apple Watch, Find My, iPhone, iPad, iPadOS, Mac, macOS and watchOS are the trademarks of Apple Inc. IOS is a trademark or registered trademark of Cisco in the U.S. and other countries and is used under license.

Use of the works with Apple badge means that a product has been designed to work specifically with the technology identified in the badge and has been certified by the product manufacturer to meet Apple Find My Network product specifications and requirements. Apple is not responsible for the operation of this device or use of this product or its compliance with safety and regulatory standards.

Notice

• After removing the device from the app, a signal tone sounds and the light flashes six times, the device does not switch off and is in pairing mode.
• If the device is not paired again within 10 minutes, it will exit pairing mode and the device and app cannot be paired at this time.
• If the device is to be paired again, the device button must be pressed once. The device emits a signal tone and the LED flashes once. The device can then be paired with the app again.
• The Kidgoo 2024 has a small pocket for the Smart Tag, which is located behind the removable inner pocket on the right-hand side.

Caution!

• Keep batteries out of the reach of children.
• Ingestion can lead to serious injury or death within just 2 hours due to chemical burns and possible perforation of the esophagus. If you suspect that your child has swallowed a button battery, contact a doctor immediately.
• Never attempt to recharge batteries that are not intended to be recharged.
• Remove exhausted batteries from the device.
• Only handle leaking batteries with gloves and dispose of them properly.
• Do not operate the device if it is visibly damaged or defective. Inspect the device for damage before each use.
• Liability and warranty claims are excluded in the event of improper connection or incorrect operation.
• The frequency of the device may not be changed, the power increased or other changes made without the agreement of Qeridoo GmbH.

FAQs

When can the device be located?

If a device is out of range for a certain period, it can be found by other Apple devices that are part of the Find My network. You can have the location displayed in the app.

How does the device prevent unwanted tracking?

If there is an unfamiliar Smart Tag in your area, your iPhone recognizes it and notifies you. If a Smart Tag is not detected, it plays a sound to make it easier to find. Note You do not have to worry about being constantly notified or a Smart Tag playing sounds. The notifications are only activated when the Smart Tag is no longer in the vicinity of its owner.

How is my privacy protected?

Only you can see where your Smart Tag is unless you consciously share your location in the Find My App. The location data and history are not stored on the Smart Tag itself. Apple devices that transmit the location of the Smart Tag also remain anonymous.

How do I replace the battery?

Open the battery compartment of the device. Replace the battery with a new CR2032 battery. Make sure the polarity is correct. Close the battery compartment and press the device button for 5 seconds to restart it.

What is the Find My Network?

The Find My community is made up of millions of iPhone, iPad and Mac users around the world. Nearby Smart Tags are localized by the community and their location is transmitted to iCloud so that the owners of the Tags can see the location in the Find My app. The Apple Find My network provides an easy, secure way to locate Qeridoo Smart Tag using the Find My app on your iPhone, iPad, or Mac, or the Find Items app on Apple Watch.

How do I know if my Qeridoo Smart Tag is in pairing mode?

After removing the device from the app, a signal tone sounds and the light flashes six times. If not paired again within 10 minutes, it will exit pairing mode. Pressing the device button once will emit a signal tone and flash the LED once, indicating it is ready to pair.

Where can I find the pocket for the Smart Tag on my Kidgoo 2024?

The small pocket for the Smart Tag is located behind the removable inner pocket on the right-hand side of the Kidgoo 2024.

FCC Warning

This device complies with part 15 of the FCC Rules.

Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user‘s authority to operate the equipment.

Note:
This equipment has been tested and found to comply with the limits for a Class B digital device, under Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used per the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.

Contact Information

Qeridoo GmbH

• Industriepark Nord 100, 53567 Buchholz Germany
• URL: www.qeridoo.de
• Mail: info@qeridoo.de
• Tel: +49 (0) 2683 9466577

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>