AllyTech EV2-G Series Intelligent Central Control Instruction Manual
- June 3, 2024
- AllyTech
Table of Contents
- AllyTech EV2-G Series Intelligent Central Control Instruction Manual
- Specification Summary
- The main parameters
- Wireless parameters
- Connection
- Block diagram
- Indicator status
- Warning
- Note
- Manufacturer information
- Read More About This Manual & Download PDF:
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
AllyTech EV2-G Series Intelligent Central Control Instruction Manual
Specification Summary
Ev2-G is a 4G version of intelligent central control terminal which is
installed on the vehicles . it provides remote communication interface for the
whole vehicle, and can provide services such as driving data acquisition,
driving track recording, vehicle positioning (GPS, Beidou), vehicle fault
monitoring,BLE communication and so on.
TBOX shall be installed in a position with good stability and concealment.
Avoid the position next to high-temperature heating parts such as mailbox,
engine, and avoid the position of cyclists and passengers.
Dimension and Drawing
Body size: 90.2mm70.2mm36.5mm
The main parameters
operating temperature range | -40℃~+60℃ |
---|---|
storage temperature range | -40℃~+60℃ |
Battery Charge temperature range* | -10℃~+60℃ |
Operating Voltage | DC12V |
Typical working current | <300mA@12V |
Quiescent current during sleep | <0.5mA@12V |
Average operating current | <300mA@12V |
MAX. output power | BT: -1.95 dBm |
GSM: 33 dBm
WCDMA: 24 dBm
LTE = 23 dBm
Frequency Stability| BT: ±30 ppm
Receiver Sensitivity| BT: -94 dBm
---|---
Modulation| GFSK (BT), GMSK,8PSK (GSM), BPSK, QPSK,16QAM,64QAM (WCDMA),
QPSK,16QAM (LTE)
Wireless parameters
modular| frequency| Maximum
transmit power
| Minimum
transmit power
---|---|---|---
GSM
| EGSM900| 33dBm±2dB| 5dBm±5dB
DCS1800| 30dBm±2dB| 0dBm±5dB
GSM850| 33dBm±2dB| 5dBm±5dB
PCS1900| 30dBm±2dB| 0dBm±5dB
WCDMA
| WCDMA B1| 24dBm+1/-3dB| <-49dBm
WCDMA B3| 24dBm+1/-3dB| <-49dBm
WCDMA B4| 24dBm+1/-3dB| <-49dBm
WCDMA B5| 24dBm+1/-3dB| <-49dBm
WCDMA B8| 24dBm+1/-3dB| <-49dBm
LTE FDD
| LTE FDD B1| 23dBm±2dB| <-39dBm
LTE FDD B2| 23dBm±2dB| <-39dBm
LTE FDD B3| 23dBm±2dB| <-39dBm
LTE FDD B4| 23dBm±2dB| <-39dBm
LTE FDD B5| 23dBm±2dB| <-39dBm
LTE FDD B7| 23dBm±2dB| <-39dBm
LTE FDD B8| 23dBm±2dB| <-39dBm
LTE FDD B28| 23dBm±2dB| <-39dBm
BT| 2400~2483.5MHz| 0dBm±2dB| /
GNSS| GPS/GLONASS/BeiDou/Galileo/ QZSS| /| /
Connection
PIN | Function | Remark |
---|---|---|
1 | VBAT | DC12V |
2 | KL15 | ACC |
3 | CAN_H | |
4 | CAN_L | |
5 | K_LINE | |
6 | GND |
Block diagram
Indicator status
Led status | equipment status | Remark |
---|---|---|
Slow flash | Network searching | 200ms on, 1800ms off |
Slow flash | Standby | 1800ms on, 200ms off |
Fast flash | Data transmission | 125ms on, 125ms off |
OFF | Deep sleep |
Warning
- Please confirm that the TBOX and connecting wire are correct before powering up the TBOX to prevent damage to the vehicle or TBOX. Don`t install or disassemble TBOX when it is powered If there is omission or misconnection, cut off the power supply before operation.
- This equipment is a wireless communication Please cut off the power supply before entering the oil depot and dangerous goods place.
- This equipment is a wireless communication It will not work normally when the wireless network is artificially shielded or in the blind area of coverage.
- If any abnormality is found during use, please go to the designated place for maintenance or contact the dealer.
- Disposal of a battery into fire or hot oven ,or mechanically crushing or cutting of a battery ,that can result in an explosion .
- Leaving a battery in an extremely high temperature surrounding environment that can result in an explosion or the leakage of flammable liquid or
- A battery subjected to extremely low air pressure that may result in an explosion or the leakage of flammable liquid or
Note
Please note that changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful
- this device must accept any interference received, including interference that may cause und esired
This equipment complies with radio frequency exposure limits set forth by the
FCC for an uncontrolled environment.
This equipment should be installed and operated with a minimum distance of 20
cm between the device and the user or bystanders.
This device must not be co-located or operating in conjunction with any other
antenna or transmitter.
This device contains licence-exempt transmitter(s)/receiver(s) that comply
with
Innovation, Science and Economic Development Canada’s licence-exempt RSS(s).
Operation is subject to the following two conditions:
- This device may not cause interference; and
- This device must accept any interference, including interference that may cause undesired operation of the
The unlicensed transceivers included in this device comply with the NRC of innovation, science and Economic Development Canada for unlicensed radios. It is allowed to operate under the following two conditions:
- The equipment shall not produce interference;
- The equipment shall accept any radio interference, even if the interference may endanger its
This equipment complies with radio frequency exposure limits set forth by the
Innovation, Science and Economic Development Canada for an uncontrolled
environment.
This equipment should be installed and operated with a minimum distance of 20
cm between the device and the user or bystanders.
This device must not be co-located or operating in conjunction with any other
antenna or transmitter.
The device complies with the uncontrolled environmental RF exposure limits set
by innovation, science and Economic Development Canada.
The installation and use of the equipment shall be kept at least 20 cm away
from the user or a third party.
The device must not be close to any other antenna or transmitter.
Manufacturer information
Product Name: TBOX. Product type: Transceiver
Model: EV2-G
Manufacturer Name: Hangzhou Zhiyuan Electronic Co., Ltd
Manufacturer Address: No.10, Naxian Street, Dalu Industrial Park, 311113
Hangzhou City, Zhejiang, P.R. China