MEKBAO PLASTIC ELECTRONIC INDUSTRIAL CO LTD 5588029 Remote Control Car Owner’s Manual
- June 10, 2024
- MEKBAO PLASTIC ELECTRONIC INDUSTRIAL CO LTD
Table of Contents
MEKBAO PLASTIC ELECTRONIC INDUSTRIAL CO LTD 5588029 Remote Control Car
Battery Installation
Power Requirement (Not Included)
Remote Control Operation
The Basic Instruction of Controlling
CAUTIONS
When the car is in motion, do not touch the wheels by hand to avoid damage to the car.
- Do not bend the antenna or point it at other people or articles to avoid hurts.
- Do not play in a place with puddles, mud or sand
Do not play on the roads or in any other dangerous places to avoid accidents.
WARNING
- CHOKING HAZARD – small parts,
- Not for children under 3 years.
BATTERY SAFETY
- The placement or replacement of batteries is to be performed by an adult.
- Remove the rechargeable battery from the chassis before charging.
- Always remove exhausted batteries from the car and the transmitter.
- Make sure the main switch is set to OFF before installing the battery pack into the car body.
- Batteries must be inserted with the correct polarity.
- Non-chargeable batteries shall not be recharged.
- Do not short-circuit the batteries.
- Always remove the batteries from the car and the transmitter after playing.
- Never throw the batteries into fire to avoid explosion or leakage.
- Do not mix batteries from different producers or new and old batteries.
- You should only use batteries of the same or equivalent types as recommended.
- Check the batteries regularly to avoid leakage.
- Keep this manual well for future reference as it contains important information about this product.
FCC
The statements should be displayed in the user manual
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, under Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used by the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This transmitter must not be co-located or
operating in conjunction with any other antenna or transmitter.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference,
- this device must accept any interference received, including interference that may cause undesired operation. changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Item NO : MM5588-711-01
Product Name: REMOTE CONTROL CAR SERIES