TERI 800 Portable Nail Dust Collector User Manual
- June 3, 2024
- TERI
Table of Contents
TERI 800 Portable Nail Dust Collector
Dear customer, the Teri™ team is grateful to you for trusting our brand and choosing our product. We hope that Teri™ dust collectors will only bring you positive emotions and keep you healthy for years to come. This is the main mission of our company.
Operation and maintenance of manicure dust collector
Check the equipment of the dust collector, particularly the power cable and the HEPA filter. Place the dust collector on the table, remove the protective stainless steel top mesh that holds the magnets. Release the filter from polyethylene. Make sure there are no foreign objects or documents in place of the filter installation. Insert the filter with the TERI logo upwards as shown. Reinstall the stainless steel top mesh. Unpack the supplied power cord and connect it to the dust collector, then plug it into a 110 to 240 volts wall outlet.
Warning! It is forbidden to switch on the dust collector without a filter! It is also forbidden to turn the filter over during operation! Turning the filter over may cause the malfunction of inter nal mechanisms, as well as blow the dust out of the filter spraying it around. To turn on the dust collector, turn the switch to the ON position. The Turbo model has a self- assessment mi croprocessor, so the turbine will start rotating only after a 6-second delay. You can adjust the rotation speed by turning the knob in both directions. To turn off the dust collector, turn the switch to the OFF position.
Filter maintenance and replacement
HEPA (High Efficiency Particulate Air or High Efficiency Particulate Arrestance) is a type of high efficiency air filter. The filter safely catches even the smallest, most dangerous, dust. All Teri™ filters are made from high quality filter fabric. To clean the filter, simply pull it out, shake the dust into a wet sink, and rinse. The filter can be treated with disinfectant solution and washed, but be sure to thoroughly dry it before use. Do not heat the filter above 90 degrees Celsius. We recommend cleaning the filter after each customer. When filter efficiency is lowered, the filter must be replaced. It is recommended to replace filters once a month. Filters can be purchased from your Teri dealer.
Warranty card for Teri™ dust collector
This coupon confirms the buyer’s right to exchange or repair the product with the specified serial number free of charge for a period of 12 months from the date of sale, in the event of failure. The warranty is void in case of improper use.
Improper use of the device is considered by:
- Exposing the device to any liquid;
- Physical damage of the device during operation, foreign objects inside the turbine;
- Excessive contamination of the device during operation, which may cause the motor to be blocked or overheat;
- Exceeding acceptable power supply parameters: 110-240 volts;
- Involvement of third parties in the design or internal scheme of the device.
In the event of improper use of the device, Teri™ reserves the right to repair the device for additional charge agreed with the buyer.
If you did not like our product, you can return it within 14 days of receiving and get its value minus the filter price With any questions regarding the operation or repair or replacement of the Teri™ dust collectors contact your local Teri dealer or in viber / telegram +38 099 32 111 92, Monday to Friday, from 10am to 5pm. If the device fails after 14 daysor more from the date of purchase, shipment of the device for repair or exchange is carried out at the expense of the buyer.
Kaitstud / Secured by https://mereneid.eu/
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>