betta VEUE | Straight Drop Installation Guide

betta VEUE | Straight Drop

TOOLS AND ADDITIONAL ITEMS REQUIRED

PART A – TOOLS REQUIRED

• Saw
• Saw
• Drill
• Screw Driver – Philips Head & Flat Head
• Jaw Pliers
• Allen Key Set
• Mallet
• Scissors

PART B – ADDITIONAL ITEMS REQUIRED (NOT SUPPLIED)
To install a VEUE | Straight Drop, the following non-stocked items are required:

• Fixings for Box/Open Brackets/Hardware (ensure appropriate fixings are used to suit application)
• Trims to conceal packing (if required)

PART C – BLIND ITEMS REQUIRED

INSTALLATION

PART A – PREPARING INSTALLATION SPACE

• STEP 1. – CHECK FOR OBSTRUCTIONS
  Check for any obstructions that may interfere in installation.

• **STEP 2. – CHECK VERTICAL & HORIZONTAL INSTALLATION DIMENSIONS

**
Check if top of installation space is level. • If H1 ≠ H2, corrective actions may need to be considered prior to installation

PART B – BOX INSTALLATION

• STEP 1 – INSTALL BOX TO WALL/CEILING

NOTE:
Use appropriate fixings to suit application. Ensure Box is Aligned and Level. Ensure 2 fasteners are used per side.

PART C – OPEN BRACKET INSTALLATION

• STEP 1 – INSTALL BRACKETS TO WALL/CEILING

NOTE:

  * Use appropriate fixings to suit application. Ensure Box is Aligned and Level. Ensure 2 fasteners are used per side.
  * Ensure brackets are aligned and level.
  * Measure brackets end to end to confirm measurement is correct.

PART D – BLIND INSTALLATION

• **STEP 1 – INSERT BLIND INTO BOX

**
User effort will be required to push the booster head/Idler pin into the adapter, a noticeable “click” will indicate that the component is correctly located.

• STEP 2 – INSERT RETAINER CLIP MKII ONTO IDLER ADAPTER
  IDLER END **

**

• **STEP 3 – FEED THROUGH MOTOR CABLE (FOR MOTOR ONLY)

**

• STEP 4 – RUN BLIND DOWN + CENTRE
  • For motor operation, ensure wiring is correct and motor is operating correctly. For gear operation, ensure operation is smooth.
  • Ensure the fabric is centered.
  • Once blind is operating correctly, proceed to the next step.

PART E – LOCK OFF SS SADDLES & ATTACH DIAMOND EYE PAD

• OPTION 1 – CLIP
  • STEP 1 – UNLOCK SADDLES AND SLIDE TO REQUIRED POSITION (SUGGESTED 100MM NOMINAL FROM END CAP), LOCK BOTH SADDLES TO THE BOTTOM RAIL
  • STEP 2 – ATTACH THE DIAMOND EYE PAD DIRECTLY BELOW SWIVEL EYE SHACKEL WITH APPROPRIATE SCREWS

PART F – INSERT BOX / COVER

• **STEP 1 – INSERT BOX 120 COVER AS SHOWN, SUPPORT THE EXTRUSION AS REQUIRED TO ENSURE SMOOTH ENGAGEMENT

**

• **STEP 2 – SECURE COVER AT BOTH ENDS

Note:** It is recommended that the Box Cover be fixed to ensure it is not accidentally dislodged.

PART G – INSTALLED STRAIGHT DROP

BOX

OPEN

TROUBLESHOOTING

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>