Black Decker Smart Stand Tree Holder Instruction Manual
- June 7, 2024
- Black Decker
Table of Contents
USER’S
MANUAL
Removal
Start position
WARNING
STAND HAS SHARP BLADES, HANDLE WITH CARE AND KEEP OUT OF THE REACH OF
CHILDREN. DO NOT PICK UP BY THE BLADES. WHEN NOT IN USE, STORE IN A SAFE
PLACE. IMPROPER USE OR CONTACT MAY RESULT IN INJURY. IF BLADE JAMS WHILE
ADJUSTING, USE EXTREME CAUTION WHEN DISLODGING IT. DO NOT USE IF DAMAGED,
BROKEN OR BLADES ARE LOOSE.
USER’S MANUAL
Smart Stand.” is extremely easy to use. By following the basic procedures
listed below you will have a trouble-free Christmas with your Christmas tree.
The Smart StandTM Christmas tree stand can be used for trees with a maximum
height of 9 ft. (2.7 meters) and with a max trunk diameter of 4.2 in (10.66
cm). The stand is only suitable for indoor use. The insertion of the tree and
the handling of the stand should only be carried out by adults.
The Christmas tree must be cut horizontally (square cut) and 8 in (20 cm) of
the lower part of the trunk must be clean of branches before insertion into
the stand. The stand should be placed on a protective floor covering. Before
you insert the tree make sure that the fastening device is placed in the START
position – as illustrated. The spring holders are fitted with protective caps
in order to prevent injury from the sharp edges of the spring. These
protection caps must be removed before you start using the stand.
If the fastening device is not in the START position, the spring holders must
be tilted inwards, and together with the movable ring (to which they are
connected) be turned clockwise, until they are in the START position. In
handling the spring holders make sure only to touch the plastic part to avoid
injury. Insert the tree into the stand until just above the spike, which is
placed in the bottom of the water reservoir. Adjust the vertical position of
the tree. Raise the tree 1-1.5 in (2.5-3.5 cm).
Push the tree forcefully into the Smart StandTM, thus ensuring that the spike
penetrates the base of the tree trunk. After erecting the Christmas tree fill
up the water reservoir. The reservoir will hold up to 415 liters of water.
Fill regularly to ensure that your tree stays fresh over the festive period.
Do not overfill. After Christmas, removing the stand is a very simple
procedure. Hold the tree with one hand, place your foot on the groove at the
base of the stand. (See illustration.) Turn the tree anti-clockwise as
indicated by the arrow (OPEN). This will release the fastening springs from
the tree. You can now simply remove the tree from the stand by lifting
vertically. The stand can be cleaned by simply using a mild household
detergent.
IMPORTANT: Should the above instructions not be followed the guarantee
will become invalid.
Manufactured by / Fabrique par / Fabricado por:
Bond Manufacturing Company, 1700 W. 4th Street, Antioch, CA 94509
1.888.841.7304 / BlackandDecker.com U.S. and Canada only / E.-U. et Canada
seulement / Solo en EE.UU. y Canada
MADE IN CHINA / FABRIOUE EN CHINE / HECHO EN CHINA
©2016 Black & Decker, Inc.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>