Vacmaster 18V 2-in-1 Cordless Stick Vacuum User Guide

: June 7, 2024
: Vacmaster

Vacmaster 18V 2-in-1 Cordless Stick Vacuum User Guide

IMPORTANT SAFETY INSTRUCTIONS

When using an electrical appliance, basic precautions should always be followed, including the following:
READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER. Failure to follow the warnings and instructions may result in electric shock, fireand/or serious injury.

WARNING –

To reduce the risk of fire, electric shock, or injury:

Do not use outdoors or on wet surfaces.
Do not allow to be used as a toy. Close attention is necessary when used by or near children, pets or plants.
Use only as described in this manual. Use only manufacturer’s recommended attachments.
Do not charge if charging adapter is damaged. If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, return it to a service center.
Do not pull or carry the charging adapter by cord, use cord as a handle, close a door on cord, or pull cord around sharp edges or corners. Do not run appliance over cord. Keep cord away from heated surfaces.
Do not unplug by pulling on charging cord.
Do not handle charger, including charger plug, and charger terminals with wet hands.
Do not put any object into openings. Do not use with any opening blocked; keep free of dust, lint, hair, and anything that may reduce air flow.
Keep hair, loose clothing, fingers, and all parts of body away from openings and moving parts.
Use extra care when cleaning on stairs.
Do not use to pick up flammable or combustible liquids, such as gasoline, or use in areas where they may be present.
Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot ashes.
Do not use without dust cup or filter in place.
Prevent unintentional starting. Ensure the product does not operate before connecting to hand vacuum, picking up or carrying the appliance. Carrying the appliance with your finger on the switch invites accidents.
Recharge only with the charger specified by the manufacturer. A charger that is suitable for one type of battery pack may create a risk of fire when used with another battery pack.
Under abusive conditions, liquid may be ejected from the battery; avoid contact. If contact accidentally occurs, flush affected area with water. If liquid contacts
eyes, additionally seek medical help. Liquid ejected from the battery may cause irritation or burns.
Do not use a battery pack or appliance that is damaged or modified. Damaged or modified batteries may exhibit unpredictable behavior resulting in fire, explosion or risk of injury.
Do not expose a battery pack or appliance to fire or excessive temperature. Exposure to fire or temperature above 130°C may cause explosion.
Follow all charging instructions and do not charge the battery pack or appliance outside of the temperature range specified in the instructions. Charging improperly or at temperatures outside of the specified range may damage the battery and increase the risk of fire.
Have servicing performed by a qualified repair person using only identical replacement parts. This will ensure that the safety of the product is maintained.
Do not modify or attempt to repair the appliance or the battery pack except as indicated in the instructions for use and care.
Always turn off this appliance before connecting or disconnecting any accessories.
Do not charge the unit outdoors.
Do not incinerate the appliance even if it is severely damaged. The batteries can explode in a fire.
For Household Use Only.

SAVE THESE INSTRUCTIONS

WARNING
Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

Product Disposal

This product contains an internal Lithium-ion battery pack formulated from environmentally sensitive materials. This product must be disposed of properly with due care for the environment. Do not dispose of product with household garbage. Consult your local waste authority for information regarding available recycling or disposal options.

WARRANTY

FOR ONE YEAR from the date of sale, this product is warranted against defects in material or workmanship when it is assembled, operated and maintained
according to all supplied instructions. WITH PROOF OF SALE, a defective appliance will be replaced free of charge. For warranty coverage details to obtain free replacement, visit the web page: www.vacmaster.com or call 866-384-8432.

This warranty does not cover filters, which are expendable parts that can wear out from normal use within the warranty period.
This warranty is void if this product is ever used for other than private household purposes.
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.

TECHNICAL DATA

Cordless Vacuum Cleaner
Voltage: 18VDC
Battery Charger:
Model: YLS0241A-T210050
Input: 100-240V~50/60Hz 0.8A
Output: 21.0V 500mA

GETTING TO KNOW YOUR VACUUM

diagram

Available online at www.vacmaster.com or call 866-384-8432.

GENERAL ASSEMBLY INSTRUCTIONS

Assembly Instructions

Unfold the vacuum folding handle. Put the vacuum folding handle upward, until there is a click from the folding handle button.
Fit the end of the main body onto the neck of the motorized powerhead and click into place.
Insert the hand vacuum into the slot on the bottom of main body, then press the handle into locked slot and click into place.
Insert the top of the charging base into the bottom of the charging base and lock into place.
Insert the charging connector into the charging port on the side of charging base.
Plug the adapter into a wall outlet.
Note: Use only the charger supplied with your cleaner to recharge.
Insert the 2-in-1 combination tool into the slot on the charging base for convenient storage.

Charging Instructions

Before charging, make sure the cordless vacuum is turned OFF. With the hand vacuum installed in the stick vacuum, insert the vacuum cleaner onto the charger base as shown. Make sure the charging adapter is plugged into an outlet.
The Hand vacuum on/off button will show the progress of the charge. While the vacuum is being charged, the battery charge indicator will be flashing. Once
fully charged, the indicator will be off.
For improved battery performance, keep the vacuum cleaner on the charging base while not in use. Do not start the vacuum cleaner while it is on the charging base.

Caution:

To optimize the battery longevity, charge the vacuum cleaner forbat least 5 hours before using for the first time.nNever charge the batteries in temperatures above 98.6°F (37°C) or below
32°F (0°C). It is normal for the charger to become warm when charging.

OPERATING INSTRUCTIONS

Using Your Vacuum Cleaner
When vacuum cleaner is fully charged, lift it off the charging base.

To start the vacuum, press the power button. The vacuum automatically starts in the HIGH speed position.
To switch the speed to LOW, press the speed control button. Press the speed control button again to switch back to HIGH speed.
To stop the vacuum, press the power button.

Using Your Hand Vacuum

To remove the hand vacuum, press the hand vacuum button and detach from the main body
To turn on, press the power button located on the handle.
To clean areas that are difficult to reach, use the 2-in-1 combination tool by inserting one end of the tool into the hand vacuum.
The combination tool can be used as a crevice tool or dusting brush. To transition from crevice to dusting brush, depress the latch on the tool and slide the part to the top of the tool.

Storing Your Vacuum

Fold handle by pressing handle release button and pulling handle backward.
To operate vacuum, unfold the handle by moving it upward until you hear a click.

CAUTION

Moving parts! To reduce the risk of personal injury, DO NOT touch the brush roll when vacuum is on. Contacting the brush roll while it is rotating can cut or cause other injuries. Always turn off before servicing. Use caution when operating near children.

MAINTAINING YOUR VACUUM

CAUTION

To reduce the risk of shock, remove vacuum cleaner from the charging base, and turn off before performing any service or maintenance.

Emptying the Dust Container & Cleaning the Filter

Remove the hand vacuum from the main body by pressing the hand vacuum release button.
Hold the unit over a trash bin and use one hand to press the two dust cup release buttons to separate the dust cup from the hand vacuum body.
Remove the filter basket from the dust cup. Empty the contents of the dust cup into a trash bin.
Remove the filter from the filter basket. Clean the accumulated debris from the filter basket and the filters.
After repeated use, it may be necessary to wash the filter basket and filter, Hand wash in lukewarm water. After washing, set aside and allow to air dry for 24 hours.

IMPORTANT: The filter and the filter basket must be completely dry before reuse.
Insert the clean and dry filter into the basket. Fit the basket into the dust cup and reconnect the dust cup to the hand vacuum.

WARNING
Do not operate vacuum cleaner without filter installed.

Cleaning the Motorized Powerhead & Blockages
The brush roll may accumulate debris such as strings, hair and fibers. This type of debris can wrap around the brush and diminish its ability to clean effectively.
To Remove Brush Roll for Manual Cleaning:

Make sure the vacuum cleaner is turned OFF then remove the hand vacuum and set aside.
Turn the unit over to access the brush roll. As shown below,push and slide the tab to the right to unlock, then lift the brush roll out of housing. Clean off debris and anything wrapped around the brush. Use a pair of scissors to remove threads, etc
Place the brush roll back into the housing by aligning the hexagon end to the powerhead first, then inserting the other end correctly into place and lock the tab.

To Remove Powerhead Blockages:

To clean out the powerhead, press the two nozzle release buttons, and pull the powerhead away from the main vacuum body.
Carefully remove any debris or blockage from the inside of the powerhead.
Reattach the powerhead onto the vacuum body.

Note: Do not damage pins; do not use scissors or other sharp objects to remove a blockage from the powerhead as these may damage the powerhead.

TROUBLESHOOTING

Should you have any problem(s) with your vacuum cleaner, review the table below for solutions to minor performance issues.

WARNING

Disconnect electrical supply before performing maintenance to the vacuum
cleaner. Failure to do so could result in electrical shock or personal injury.

PROBLEM

|

POSSIBLE CAUSE

|

SOLUTION

---|---|---

Vacuum will not power on.

| Battery may be depleted.| Charge the battery as instructed.
Wrong charger being used.| Be sure to use only the charger supplied with your product.
Hand vacuum is

not installed properly.

| Remove hand vacuum and reattach ensuring that it is securely in place.
Charging connector is not fully plugged into the charging base.|

Be sure the charging connector is fully inserted in the charging base.

Charging plug is not fully plugged into outlet.| Be sure charging plug is fully plugged into outlet.

Battery charge indicator does not illuminate.

|

Charging adapter is not plugged in.

| Be sure the charging adapter is plugged in properly to the outlet and to the charging port on the bottom of the charging adapter.
Debris accumulated on the metal charge contacts on the hand vacuum, main body and charging adapter.|

Be sure no debris is accumulated on the metal charger contacts on the hand vacuum, main body and charging adapter.

The electrical outlet is out of power.| Ensure that the outlet is supplying power to the charger.

Motorized brush not turning.

|

Brush roll is jammed.

|

Remove obstruction. Follow instructions.

---|---|---
Brush roll needs to be reset.| Turn the unit off and remove the obstruction, then turn back on.
Brush roll is not installed well.| Remove brush roll and reinstall following instructions.

Vacuum not picking up or suction power is weak.

| Dust cup is full.| Empty dust cup.
Filter needs cleaning.| Follow filter cleaning instructions.
Filter needs to be replaced.| To purchase online at www.vacmaster.com or call 866-384-8432.
Battery may be depleted.| Charge the battery as instructed.
Dust cup is not installed well.| Check dust cup for correct installation and

ensure it is snapped firmly in place.

Dust escapes from vacuum.

| Filter is missing or installed incorrectly.|

Check filter for correct installation.

Filter is damaged and needs to be replaced.| To purchase online at www.vacmaster.com or call 866-384-8432.
Dust cup installed incorrectly.| Position dust cup correctly and snap firmly

into place.

Vacuum turns off on its own.

| Battery may be depleted.| Charge the battery as instructed.
Brush roll is jammed causing motor protection system activated.|

While off, remove obstruction and then turn unit on.

For further questions, call our support team at 866-384-8432.