behringer Active 300-Watt 2-Way Monitor Speaker System User Guide
- June 7, 2024
- Behringer
Table of Contents
Quick Start Guide
EUROLIVE F1320D
Active 300-Watt 2-Way Monitor Speaker System with 12″ Woofer, 1″ Compression Driver and Feedback Filter
2 EUROLIVE F1320D
EN Important Safety Instructions
CAUTION
RISK OF ELECTRIC SHOK!
DO NOT OPEN!
Terminals marked with this symbol carry electrical current of sufficient magnitude to constitute risk of electric shock. Use only high-quality professional speaker cables with ¼” TS or twist-locking plugs pre-installed. All other installation or modification should be performed only by qualified personnel.
This symbol, wherever it appears, alerts you to the presence of uninsulated dangerous voltage inside the enclosure – voltage that may be sufficient to constitute a risk of shock.
This symbol, wherever it appears, alerts you to important operating and maintenance instructions in the accompanying literature. Please read the manual.
Caution
To reduce the risk of electric shock, do not remove the top cover (or the rear
section). No user serviceable parts inside. Refer servicing to qualified
personnel.
Caution
To reduce the risk of fire or electric shock, do not expose this appliance to
rain and moisture. The apparatus shall not be exposed to dripping or splashing
liquids and no objects filled with liquids, such as vases, shall be placed on
the apparatus.
Caution
These service instructions are for use by qualified service personnel only. To
reduce the risk of electric shock do not perform any servicing other than that
contained in the operation instructions. Repairs have to be performed by
qualified service personnel.
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with dry cloth.
7. Do not block any ventilation openings. Install in accordance with the
manufacturer’s instructions.
8. Do not install near any heat sources such as radiators, heat
registers, stoves, or other apparatus (including amplifiers) that produce
heat.
9. Do not defeat the safety purpose of the polarized or grounding-type
plug. A polarized plug has two blades with one wider than the other. A
grounding-type plug has two blades and a third grounding prong. The wide blade
or the third prong are provided for your safety. If the provided plug does not
fit into your outlet, consult an electrician for replacement of the obsolete
outlet.
10. Protect the power cord from being walked on or pinched particularly
at plugs, convenience receptacles, and the point where they exit from the
apparatus.
11. Use only attachments/accessories specified by the manufacturer.
12. Use only with the cart, stand, tripod, bracket, or table specified by
the manufacturer, or sold with the apparatus. When a cart is used, use caution
when moving the cart/apparatus combination to avoid injury from tip-over.
13. Unplug this apparatus during lightning storms or when unused for long
periods of time.
14. Refer all servicing to qualified service personnel. Servicing is
required when the apparatus has been damaged in any way, such as power supply
cord or plug is damaged, liquid has been spilled or objects have fallen into
the apparatus, the apparatus has been exposed to rain or moisture, does not
operate normally, or has been dropped.
15. The apparatus shall be connected to a MAINS socket outlet with a
protective earthing connection.
16. Where the MAINS plug or an appliance coupler is used as the
disconnect device, the disconnect device shall remain readily operable.
17. Correct disposal of this product: This symbol indicates that this
product must not be disposed of with household waste, according to the WEEE
Directive (2012/19/EU) and your national law. This product should be taken to
a collection center licensed for the recycling of waste electrical and
electronic equipment (EEE). The mishandling of this type of waste could have a
possible negative impact on the environment and human health due to
potentially hazardous substances that are generally associated with EEE. At
the same time, your cooperation in the correct disposal of this product will
contribute to the efficient use of natural resources. For more information
about where you can take your waste equipment for recycling, please contact
your local city office, or your household waste collection service.
18. Do not install in a confined space, such as a book case or similar
unit.
19. Do not place naked flame sources, such as lighted candles, on the
apparatus.
20. Please keep the environmental aspects of battery disposal in mind.
Batteries must be disposed-of at a battery collection point.
21. Use this apparatus in tropical and/or moderate climates.
LEGAL DISCLAIMER
MUSIC Group accepts no liability for any loss which may be suffered by any person who relies either wholly or in part upon any description, photograph, or statement contained herein. Technical specifications, appearances and other information are subject to change without notice. All trademarks are the property of their respective owners. MIDAS, KLARK TEKNIK, LAB GRUPPEN, LAKE, TANNOY, TURBOSOUND, TC ELECTRONIC, TC HELICON, BEHRINGER, BUGERA and DDA are trademarks or registered trademarks of MUSIC Group IP Ltd. © MUSIC Group IP Ltd. 2017 All rights reserved.
LIMITED WARRANTY
For the applicable warranty terms and conditions and additional information regarding MUSIC Group’s Limited Warranty, please see complete details online at music-group.com/warranty.
8 EUROLIVE F1320D
EUROLIVE F1320D Controls
Controls
First group control
(1) The POWER LED lights up when the loudspeaker is put into operation.
(2) The CLIP LED lights up when signal distortion occurs. Reduce the
volume with the LEVEL
control until the CLIP LED does not light up any more, or occasionally lights
up at signal peaks.
(3) To set the volume of the LINE or MIC signal, use the LEVEL control. The left half of the control range is for attenuating the LINE signal. The right half is for raising the level of the MIC signal.
LEVEL ADJUSTING: Turn the LEVEL control whose signal you want to adjust slowly to the right until the CLIP LED (2) lights up only at signal peaks. The LED is not supposed to glow continuously.
Equalizer
(4) The F1320D features a 3-band sound control. Each band provides a maximum
boost/cut of 15 dB. At center position the equalizer has a flat response.
The upper ( EQ HIGH ) and the lower band ( EQ LOW ) are shelving
filters that boost and cut all frequencies above and below the crossover
frequency. The crossover frequencies of the upper and lower bands are at 12
kHz and 80 Hz, respectively. The mid band ( EQ MID ) is a peak filter the
center frequency of which is at 2.5 kHz.
Feedback filter (notch filter)
Feedback may occur at high volume levels or under difficult stage situations. Use the FEEDBACK FILTER function ((5), (6)) to reduce feedback. To learn more about the feedback filter, read section 3.4 “Notch filter.”
(5) This switch turns on the feedback filter.
(6) This control adjusts the center frequency of the feedback filter.
LINK OUTPUT
(7) + (8) The LINK OUTPUT is directly connected to the inputs of the F1320D and carries the input signal with no processing applied. In this way, you can route the signal to the input of another device (for example, a second F1320D).
MIC/LINE INPUT
(9) Use this ¼” stereo jack to connect a signal source that has ¼” output.
(10) Use this XLR connector to connect a signal source that has XLR output.
Sidepanel F1320D
(11) Press POWER to turn on your F1320D.
(12) You can replace fuses at the FUSE SWITCH of the F1320D. Always replace fuses with the same type.
(13) The mains connection is established using a cable with an IEC mains connector. This cable is delivered with the F1320D. To avoid ground-loop hum, loudspeakers and mixing consoles should be connected to the same power circuit.
Check Outbehringer.com for Full Manual
Specifications
Output Power
Low-Frequency Range
RMS @ 1% THD| 160 W @ 8 Ω
Peak Power| 225 W @ 8 Ω
High-Frequency Range
RMS @ 1% THD| 40 W @ 8 Ω
Peak Power| 72 W @ 8 Ω
Mic/Line Inputs
XLR Connector
Sensitivity| -50 dBu to 0 dBu
Impedance| 20 kΩ balanced, 30 kΩ unbalanced
¼” TRS Connector
Sensitivity| -50 dBu to 0 dBu
Impedance| 20 kΩ balanced, 30 kΩ unbalanced
Link Output
| XLR connector | **** |
|---|
**Equalizer**
| High | 12 kHz / ±15 dB |
|---|---|
| Mid | 2.5 kHz / ±15 dB |
| Low | 80 Hz / ±15 dB |
**Feedback Filter**
| Filter frequency | 300 Hz to 6 kHz |
|---|---|
| Level reduction | max. 15 dB |
| Q factor | 20 |
**Loudspeaker System Data**
| Frequency range | 60 Hz to 16 kHz (-10 dB) |
|---|---|
| Maximum sound pressure level | 115 dB /118 dB (half space) @ 1 m |
| Limiter | optical |
**Power Supply/Voltage (Fuses)**
| USA/Canada | 120 V ~ , 60 Hz (T 4.0 A H 250 V) |
|---|---|
| UK/Australia | 240 V ~ , 50 Hz (T 2.0 A H 250 V) |
| Europe | 230 V ~ , 50 Hz (T 2.0 A H 250 V) |
| Korea | 220 V ~ , 60 Hz (T 2.0 A H 250 V) |
| China | 220 V ~ , 50 Hz (T 2.0 A H 250 V) |
| Japan | 100 V ~ , 50/60 Hz (T 4.0 A H 250 V) |
| Power consumption | max. 300 Watts |
| Power supply | switch mode |
| Mains connection | standard IEC receptacle |
**Dimensions/Weight**
| Dimensions (H x W x D) | appr. 360 x 580 x 406 mm (14.2 x 22.8 x 16.0″) |
|---|---|
| Weight | appr. 15kg (33.0 lbs) |
Other important information
EN Important information
1. Register online. Please register your new MUSIC Group equipment right after you purchase it by visiting behringer.com. Registering your purchase using our simple online form helps us to process your repair claims more quickly and efficiently. Also, read the terms and conditions of our warranty, if applicable.
2. Malfunction. Should your MUSIC Group Authorized Reseller not be located in your vicinity, you may contact the MUSIC Group Authorized Fulfiller for your country listed under “Support” at behringer.com. Should your country not be listed, please check if your problem can be dealt with by our “Online Support” which may also be found under “Support” at behringer.com. Alternatively, please submit an online warranty claim at behringer.com BEFORE returning the product.
3. Power Connections. Before plugging the unit into a power socket, please make sure you are using the correct mains voltage for your particular model. Faulty fuses must be replaced with fuses of the same type and rating without exception.
FEDERAL COMMUNICATIONS COMMISSION COMPLIANCE INFORMATION
BEHRINGER
EUROLIVE F1320D
Responsible Party Name: MUSIC Group Services NV Inc.
Address: 5270 Procyon Street Las Vegas, NV
89118 USA
Phone Number: +1 702 800 829 0
EUROLIVE F1320D
complies with the FCC rules as mentioned in the following paragraph:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help
This device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
Important information:
Changes or modifications to the equipment not expressly approved by MUSIC Group can void the user’s authority to use the equipment.
Dedicate Your Life to MUSIC
Documents / Resources
|
behringer Active 300-Watt 2-Way Monitor Speaker
System
[pdf] User Guide
Active 300-Watt 2-Way Monitor Speaker System 12 Woofer 1 Compression Driver
and Feedback Filter, EUROLIVE F1320D
---|---