WISELOIN T3 Bluetooth Earbuds User Manual
- June 4, 2024
- WISELOIN
Table of Contents
WISELOIN T3 Bluetooth Earbuds
Thanks for your purchase from Wiselion. For the best performance and safety purposes, please read this manual carefully before using the product. Please keep this manual for further reference.
Product Introduction
Package Contents
- 2x Bluetooth Earbuds
- 1x Type-C Charging Cable
- 1x Battery Charging Case
- 3x Ear Tip Sets (S/M/L)
Specifications
Earbud Function
Pairing earbud with the cellphone
Earbuds are paired for the first time
Take the two earphones out of the charging box, the earphones are connected
successfully and enter the pairing state. The main earphones’ white and green
lights flash alternately.
Paired phone
Turn on the Bluetooth on the cellphone and search “T3” to connect. The prompt
“connected” appears after a successful pairing.
Charging for the battery box
Connect the attached Type-C cable to charge the battery box. White light is
always on. When the charging box is fully charged, the green light is on. The
battery box low battery alarm: White light flashes for 5 seconds within 2
minutes.
FCC STATEMENT
NOTE:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.