UBSAN Lcd Monitor Instructions
- June 7, 2024
- UBSAN
Table of Contents
UBSAN Lcd Monitor Instructions
Aircraft + HS001+ HT015 Transmitter+ HV002 Video glasses
HS001 LCD Display
Main interface
Display component breakdown
HS001 key functions
No.
| Key/button/Switch|
Function
---|---|---
1
| Power Switch| Push up/ON to turn on the transmitter. Push down/OFF to turn
off.
2| 2 PhotoNideo mode switch button|
PhotoNideo mode switch button
3
| PhotoNideo button| Short press to take photos/start and end video
recordings.
4| Main Menu key|
Short press to enter the Main Menu. Use in conjunction with the +/keys to adjust screen brightness/contrast/chrominance/the 5.8GHz frequency and to check firmware information.
5
| Binding/Clear screen button| Hold while powering the screen on to initiate a
binding. Short press while the screen is on to clear the screen; short press
again to show content.
6| TF (Micro-SD) slot|
Insert an SD card into the LCD screen’s slot to take and store photos and video recordings.
7
| Micro-USB port| Used for charging and for updating firmware (only when
necessary).
8| Charging status LED|
While the screen is charging, the LED is a solid red. After charging is complete, the LED turns solid green.
Installing the TF (Micro-SD) card
Insert the SD card in the TF card slot located on the display’s right hand side. To eject the SD card from the slot, push the Micro-SD inwards (it will pop out).
Charging
The HS001 is paired with a rechargeable 7.4V, 2300mAh Li-Po. Be sure to use the provided Hubsan dedicated charger for charging. Fully charge the battery before use.
Connect the charger’s USB adapter to a PC terminal and then the battery to the
charger. Charging time is approximately 150min; battery life is 120 minutes.
Be sure to charge the battery before each flight.
- Make sure the battery is fully charged before each flight.
- Please do not leave unattended while charging.
- When charging is complete, disconnect the charger and battery from power immediately
HV002 Video glasses
Installing the HS001 display
-
Option 1:
Secure the HS001 display to the HT015’s mobile device bracket.
-
Option 2 (with the HV002 video goggles):
Press the release key on the HV002 goggles to release its face panel. Install the HS001 into the exposed compartment and shut the panel. After the installation, one may put the goggles on and adjust to fit with the adjustable head strap.
Warning : After installing the display, check if the face panel is loose.
If yes, please
readjust accordingly.
Binding the aircraft and transmitter
-
Pull and hold the throttle to its lowest position. Hold down the Photo key and power the transmitter on; allow the transmitter to enter binding mode.
-
Power the HS001 on by pushing the power switch up. Long press the display’s binding button (shown below) to allow the HS001 to enter binding mode. The display will beep three times.
-
Connect the drone to its battery. While all units are in either binding or pairing modes, please do not touch, press or move any of the transmitter joysticks, buttons or keys. Doing so will cause the aircraft to drift or perform unstably during flight. After binding is successful, the transmitter’s binding status LED will be a solid blue.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>