VTIN Bluetooth Speaker User Manual
- June 7, 2024
- VTIN
Table of Contents
VTIN Bluetooth Speaker User Manual
MODEL: BH338A
PACKING LIST
- Speaker
- charging cable
- audio cable
- user manual
- charging indicator card
DIAGRAM
- Power/mode switch button
- Bluetooth indicator light
- Volume down/last track
- Volume up/next track
- Pause/play/Bluetooth function button
- TF card slot
- AUX-in port
- Micro-USB charging port
- Charging indicator light
- Reset button
SPECIFICATIONS
Paring name
|
VTIN Punker mini
---|---
Bluetooth version
|
V5.0
Signal distance
|
33 ft
Compatible protocol
|
TF card MAX capacity
|
32 G
Charging voltage
|
5V 1A
Waterproof level
|
IPX5 Splash proof
Bluetooth Connection
Long press the power”% “button for 2 seconds to power on. Enable Bluetooth
on your smartphone, search the Bluetooth name “VTIN Punker mini” and click to
pair. When the pairing is complete, the Blue indicator light remains on.
Operation Guides
- Power ON / OFF: Long press the “%” button for 2 seconds to turn on or off the
- Volume control: Short press the ” ” button to increase the volume or short press the ” ” button to decrease the volume. When the volume is adjusted to the highest , the blue indicator light will flash Mice.
- Long press the ” ”button for 2 seconds to skip to next track or long press the ” ”button for 2 seconds to skip to previous track.
- Pause / Play: When playing music, short press the “ __” button to pause or play music.
- Handsfree call: With your smartphone connected, short press the ” ” button to answer the incoming ¢aII and short press the ” “button again to hang up the current call; Long press the “ “ button for 2 seconds to reject the incoming call.
- Switch the mode: When the speaker is in power-on state, short press the “% “button to switch the mode among Bluetooth, AUX-IN and TF card.
- If you want to connect to the other Bluetooth device, long press the ”@ ” button to disconnect from the connected device A. Then, the speaker enters pairing mode, which needs you to search the Bluetooth device “VTIN Punker mini“ on the device B. Click to pair and connect to the device B.
FCC STATEMENT
Operation is subject to the following three conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation
- This device has been evaluated to meet general RF exposure The device can be used in portable exposure condition without restriction.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limia are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.