nutrichef Wine Chilling Refrigerator User Manual

June 7, 2024
nutrichef

nutrichef Wine Chilling Refrigerator

CLASSIC GLASS DOOR SERIES

|

STAINLESS STEEL DOOR SERIES

---|---

PKCWC120

| 12 bottles| PKCWC12| 12 bottles
PKCWC150| 15 bottles| PKCWC15|

15 bottles

Please read all instructions carefully and follow all guidelines and rules for optimum performance and proper appliance usage

IMPORTANT SAFETY INSTRUCTIONS

WARNING

To reduce the risk of fire, electrical shock, or injury when using your appliance, follow these basic precautions

  • Read all instructions before using the Cooler.

  • DANGER or WARNING: Risk of child entrapment.
    Child entrapment and suffocation are not problems of the past. Junked or abandoned appliances are still dangerous even if they will “just sit in the garage a few days”.

  • Before you throw away your old Cooler: Take off the door. Leave the shelves in place so that children may not easily climb inside.

  • Never allow children to operate, play with, or crawl inside the appliance.

  • Never clean appliance parts with flammable fluids. The fumes can create a  fire hazard or explosion.

  • Do not store or use gasoline or any other flammable vapors and liquids in the vicinity of this or any other appliance. The fumes can create a fire hazard or explosion.

  • Do not repair or replace any part of the Cooler or attempt any servicing unless specifically recommended in the user-maintenance instructions or in published user-repair instructions.
    Replace the fuse with the same type.

PARTS DIAGRAM

  • Model No: PKCWC120

  • Model No: PKCWC12

  • Model No: PKCWC150

  • Model No: PKCWC15

  1. Cabinet
  2. Fan
  3. Fan Cover
  4. Shelves
  5. Foot
  6. Upper Hinge
  7. Door Gasket
  8. Glass Door
  9. Stainless Steel Handle
  10. Bottom Hinge
INSTALLING THE STAINLESS STEEL HANDLE

For PKCWC12, PKCWC15 Models only

This wine cellar includes a stainless steel handle. To install the handle please follow the below instructions:

  1. Pull away the door gasket in the area where the handle is to be installed on the left side as shown below in illustration #1. The gasket can easily displaced by hand, no tools are necessary.

  2. Align the handle with the screws installed. Tighten the screws using a Phillips head screwdriver until the handle sets both flush and secured tightly against the door frame.

    (DO NOT over tighten as this will cause damage to the handle assembly).

  3. Replace the door gasket to its original position.

1. Gasket 2. Phillips Head Screw Driver
3. Phillips Head Screw 4. Handle

TEMPERATURE CONTROL

  • It is recommended that the wine cooler should be installed in an area where the ambient temperature is between 16-26ºC (60-80ºF).
  • If the ambient temperature is above or below the recommended ranges, the unit’s performance may be affected, and extreme cold or hot conditions may cause the interior temperature to fluctuate. This will prevent the optimal range from being reached. In addition, keep in mind that the temperature may fluctuate depending on whether the interior light is on or off, and whether the bottles are located on the upper, middle, or lower racks.

RECOMMENDED TEMPERATURES FOR CHILLING WINE

RED WINES 14 – 18ºC 57- 65ºF
DRY/ WHITE WINES 9 – 14ºC 49- 58ºF
ROSE WINES 10 – 11ºC 51- 53ºF

TEMPERATURE RANGES FOR YOUR WINE COOLER

PKCWC12/ PKCWC120 5 – 18° C 41 – 64° F
PKCWC15/ PKCWC150 5 – 18° C 41 – 64° F
CONTROL PANEL

For PKCWC12 / PKCWC120 / PKCWC15 / PKCWC150 Models only.

  • You can select temperature display between Fahrenheit and Celsius setting by pressing this button
  • You can turn the interior light ON or OFF by short pressing this button.

SETTING THE TEMPERATURE CONTROL

  • Your cooler is equipped with a control panel lock feature which will lock itself automatically 20 seconds after the last time a button is pressed.

  • Press the button to unlock the control panel. You will hear a “BEEP” sound to alert you that the control is now active.

  • You can manually adjust the temperature inside Cooler by pressing the buttons and on the display panel.
    The two buttons on the panel and adjust the temperature in increments of 1ºC or 1ºF

  • You can also turn the interior light on or off by pressing the “ ” button.

  • The light will be turned OFF automatically if it remains ON for 10 minutes. You have to push the “ ”

ELECTRIC DIAGRAM

(For PKCWC120, PKCWC150, PKCWC12, PKCWC15 only)

INSTRUCTION

Note:

  • Position your wine cooler so that the plug is accessible
  • Keep your wine cooler out of direct sunlight.
  • Do not place next to heat generating appliance.
  • Place the wine cooler on a leveled surface that is strong enough to support the unit when it is fully loaded. To level your wine cooler, adjust the front feet located at the bottom of the unit.

Important:

  • Position the cooler in a dry and airy place with ambient temperature between 5-32°C (41-90°F).
  • Before connecting the unit to a power source, allow it stand upright for approximately 2 hours. This will reduce the possibility of any system malfunctions which may have occurred from handing during transportation.
  • When positioning the wine cooler, 6 inches of space at the back and 10 inches of space both sides are suggested. Do not put any objects on top of the unit which may block the air circulation.
Power Connection
  • This wine cooler should be properly grounded for your safety and in order to minimize the possibility of electrical shock, the power cord of this unit is equipped with a 3-pin plug which fits with 3-pin wall outlets.
  • Never cut or remove the ground wire from the supplied power cord.
  • The use of extension cords is not recommended.
  • This unit requires a standard 110V-60Hz electrical outlet with a 3-pin plug.
  • The cord should be secured behind the wine cooler. Also, to prevent accidental injury, do not expose or dangle the cord.

VENTILATION

  • Do not install the wine cooler in a closed cabinet without proper ventilation.
  • Please leave at least 6 inches distance between the wall and the wine cooler.
  • Do not remove the feet of the wine cooler. Keep at least 50mm of ground clearance.

CLEANING

  • UNPLUG the Wine Chiller, and remove all items including shelves.
  • Wash the inside surfaces with a warm water and baking soda solution. The solution should be about 2 tablespoons of baking soda to a quart of water.
  • Wash the shelves with a mild detergent solution.
  • Wring excess water out of the sponge or cloth when cleaning area of the controls, or any electrical parts.
  • Wash the outside cabinet with warm water and mild liquid detergent. Rinse well and wipe dry with a clean soft cloth.

TROUBLE SHOOTING

PROBLEM POSSIBLE CAUSES AND MAINTENANCE MEASURES
The wine cooler will not operate
  • The unit may be plugged in using a different voltage. Also, the circuit breaker may be tripped or there is a blown fuse.

The wine cooler is not cold enough|

  • Check the temperature control settings, as the external environment may be too hot and affect the cooling capacity. The most ideal ambient temperature for compressor cooling wine cooler is 5C-32C (41F-90F).
  • The door may be opened too frequently.
  • The door is not closed completely.
  • The door seal does not seal properly.
  • The wine cooler does not have sufficient clearance, as it will affect the heat dissipation. Please make sure there is nothing near Heat sink fan on the back within 10cm area.
  • The wine cooler includes too much items, as the IT need some time to cool down and remain stable. Please wait for 24h and check again.

The wine cooler vibrates while operating|

  • Make sure the unit is leveled. Please adjust the foot if necessary

The wine cooler produces a lot of noise|

  • The unit may not be leveled.
  • Check the fan, as noise will increasing if your wine cooler have much dust on the fan after using for a long time. Please use hair dryer and set strong position to blow away dust on the fan.

The wine cooler will not close properly

|

  • The unit may not be leveled.
  • The doors are reversed and not properly installed.
  • The seal is weak.

The LED display does not work|

  • There may be a problem wit h t he main control board.
  • There is a problem wit h t he plug. Please check t o assure plug is be in good connect ion wit h socket or already plugged in.
  • The digital control panel will lock automatically after 10 seconds if no further operation Please press t he unlock but t on t o activate the wine cooler.

There is an LED display error|

  • There is a PCB problem.

The buttons do not function|

  • The temperature control panel may be damaged.

Frost or ice developed inside the wine cooler|

  • Ambient temperature too low.
  • The wine cooler needed to be restarted

Questions? Issues?
We are here to help!
Phone: (1) 718-535-1800
Email: support@pyleusa.com

This product can expose you to a chemical or group of chemicals, which may include ”Styrene” which is known in the state of California to cause cancer, birth defects, or other reproductive harm. For more info, go to https://www.p65warnings.ca.gov/.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals