My SpinWave Robot First Use, Charging, & Cleaning | Support
- June 7, 2024
- Bissell
Table of Contents
↵
After taking your Robot out of the box, please remove all protective
packaging and the two white bumper guards located on either side of the bumper. These will prevent your Robot from navigating as it was designed to, please see steps below for setting up your Robot for first use:
Charging:
-
Plug in docking station against the wall in an area that has hard floor and 40 inches of clearance on all sides
-
Place docking station tray against the wall
-
Place robot onto charging dock and turn on
- Allow 4-5 hours for the first charge – Robot may be fully charged when only showing 2 battery lights in the BISSELL Connect App
-
The robot may return to the dock if it thinks it’s cleaned the entire accessible area, sometimes before the entire battery is consumed
- For more information on Navigation > Go to SpinWave Navigation
Dry Mode:
- Insert dirt tank
- Clear any objects from the cleaning path and around stairs
- Turn robot on to clean either using the BISSELL Connect App, or by pressing the Start/Pause button on the top of the Robot
Wet Mode:
-
Remove water tank cap by twisting and pulling up
-
Fill water tank with water to the water fill line
-
Pour BISSELL formula into water tank to the formula line
-
Put cap back onto water tank by twisting until lined up with the lock
-
Insert water tank back into robot
- Keep water tank level when transporting it back to the SpinWave robot
-
Clear any objects from the cleaning path and around stairs
-
Begin cleaning using the BISSELL Connect App, or by pressing the Start/Pause button on the top of the robot
Cleaning Modes & Patterns:
-
Adjust your robot’s pattern and suction or flow mode by clicking on the pattern & mode on the bottom of the robot screen in the App
-
Auto:
- Turn the machine on manually hitting the Start/Pause button or turn the machine on in the App
- Schedule a clean for the machine to run Auto cleaning > Follow steps HERE to set up a schedule
-
Spot:
- Set your robot in the area where you want it to Spot Clean
- Manually start Spot cleaning by tapping the Start/Pause button 3 times
- You can also start Spot cleaning in the app by choosing the Spot pattern button and choosing apply
- Spot cleaning automatically defaults to Max flow or suction
-
Modes (only available to change in the App):
- Mode controls the suction power or flow rate of the robot, depending if you are using dry or wet mode
- Your robot will default to Mid suction or flow rate in Auto cleaning
-
Recipient Email
Your Email
Your Name
Was this answer helpful?
Yes
No