ProHeat 2X® Revolution® Pet Carpet Cleaner Removing the Handle No Spray | Support
- June 7, 2024
- Bissell
Table of Contents
Have you checked the Clean Water Tank for Spray?
-
No > Go to No Spray
-
Yes > Turn off and unplug machine
-
Remove clean water tank
-
A Philips head screwdriver and a thin flathead screwdriver are needed to remove the handle
-
Remove the screw in the back of the machine going thru the carry handle using a Phillips head screwdriver
-
Gently pry the carry handle off by pulling outward at the sides with your hand
-
Repeat on both sides
-
Carefully use a flathead screwdriver to pry up the grey plastic tab on the plastic base of handle
-
While you pry this forward the metal handle can easily slide right up and out of it
-
Remove the base of the handle by hand, it should pop off easily and can be slid back on the handle
-
Push down the plunger receiver with a screwdriver (black button inside where the handle goes in)
- Is water spraying?
- No > Visit a BISSELL Authorized Service Center or Contact Us
- Yes > Press the trigger on the handle, while it is detached > Is trigger stuck or displayed?
- Yes > A new handle should be ordered > Go to Parts & Supplies
- No > Reinstall handle and check for spray
-
Has this resolved the issue?
- Yes > Great! Glad we could get you back to cleaning!
- No > Visit a BISSELL Authorized Service Center or Contact Us
-
Recipient Email
Your Email
Your Name
Was this answer helpful?
Yes
No