My Big Green Complete® Deep Cleaner & Vacuum is not spraying | Support

• Empty dirty water tank

  • Fill solution tank with water

  • Plug machine into a working outlet

  • Disconnect wand from grip trigger handle

  • Turn machine on & press trigger

  • Check for spray at the small spray tip where the water comes out

  • If there is spray

    • Clean out spray tip on tool using a paper clip
    • Wand pieces and tool needs to be pressed firmly together

  • If not spraying:

  • Remove solution tank

    • Verify the red gasket is correctly attached to the cap on the bottom of the tank
    • The red auto-load gasket should face outward, screen should be inside, not outside
    • If missing, it should be replaced

  • While holding tank over sink (cap side down) push up on the X-valve

    • Water should flow out
    • If not, cap & insert should be replaced

  • Return tank to machine

  • Remove hose solution line

  • There should be 2 small O-rings on the fitted end of the hose solution line

    • If missing, the hose should be replaced

  • Reinsert hose solution line

  • After inserting, twist to right to lock

  • Run the machine for 5 minutes, with all 3 buttons engaged

    • This should dislodge any clogs

If all steps above have been followed and still no spray, visit a BISSELL Authorized Service Center or Contact Us

• Recipient Email

Your Email

Your Name

Was this answer helpful?

Yes
No

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>