My SpinWave Robot is dispensing too much solution in Mop Mode | Support
- June 7, 2024
- Bissell
Table of Contents
If you are experiencing too much solution being put onto your floor while
your SpinWave robot is in Mop Mode, follow these steps to resolve:
-
Remove Clean Water Tank
-
Check that the correct amount of water and BISSELL formula are in the Clean Water Tank
- Filling the water tank with incorrect formula could result in inconsistent flow rates and too much solution on your floor
- Re-seat Water Tank in robot until it clicks
-
If you are using the BISSELL App, change the flow rate to a lower mode > Click the mode on the bottom of the Robot screen > Choose Low and then Apply
- If robot is performing an Auto Clean it will default to the mid flow rate
-
Has this resolved the issue?
- Yes > Great! Glad we could get you back to cleaning!
- No > Visit a BISSELL Authorized Service Center or Contact Us
-
Recipient Email
Your Email
Your Name
Was this answer helpful?
Yes
No
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>