My QuickSteamer® Carpet Cleaner is not spraying | Support
- June 7, 2024
- Bissell
Table of Contents
-
Unplug the machine
-
Remove solution tank and fill with water
-
While holding tank over sink push up on the X – valve on the end of the cap
- Water should flow out
- If no water flows from cap
- Remove cap and soak in warm water for 30 minutes
- If water flows out of cap
- Check the trigger for tension
-
If the trigger does not have tension
- Remove handle and re-install
- Check the 3 handle screws
- The top screw should be recessed 1/2 inch from the outside of the raised screw hole
- Re-install tank
- Squeeze trigger
- Spray is gravity fed, it may take 15-30 seconds to reach the spray tips
- The spray bar can be cleaned by inserting a paper clip into the spray holes
- If machine still does not spray, visit a BISSELL Authorized Service Center or Contact Us
-
Recipient Email
-
Your Email
Your Name
Was this answer helpful?
Yes
No
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>