My TurboClean/PowerForce/PowerClean PowerBrush Pet has No Suction | Support

If you are experiencing No/Low Suction, follow these steps to resolve:

• Turn off and unplug machine

• Remove dirty water tank by pulling out and up on the side latches

  • Lift up on the handle to remove

• Open rubber tab on top of dirty water tank, pour out dirty water

  • Rinse tank thoroughly
  • Close rubber tab

• Inspect dirty water tank for cracks or damage

  • If damaged, replace dirty water tank > Go to Parts & Supplies 

• Remove debris from red filter

• Plug machine in and turn on

• Put your hand over the red filter to feel for suction

• Is there suction?

  • Yes > Turn off and Unplug machine
  • No > Visit a BISSELL Authorized Service Center or Contact Us

• Remove float stack from dirty water tank unscrewing the ring at the bottom of the tank

• Rinse the float stack under water to remove any debris

  • Ensure that float stack can freely move up and down

• Put float stack back into dirty water tank aligning the arrow on the float with the notch on the tank

  • Twist ring into place to secure float

• Grab the top of nozzle and pull away to remove it

• Rinse nozzle under water and wipe debris from machine where nozzle was

• Replace nozzle aligning the top into channel in front of red filter, use both hands to push bottom portion of nozzle into place

• Return dirty water tank to machine, secure with latches

• Plug machine in and turn on

• Check for suction by performing a few wet and dry cleaning strokes

  • Has this resolved your issue?
  • Yes > Great! Glad we can get you back to cleaning
  • No > Is there spray?
    • Yes > Visit a BISSELL Authorized Service Center or Contact Us
    • No > Go to Low/No Spray
      

• Recipient Email

Your Email

Your Name

Was this answer helpful?

Yes
No

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>