My SpinWave Robot Brush is Not Turning in Dry Mode | Support
- June 7, 2024
- Bissell
Table of Contents
Note: The brush will only turn in Dry Mode
- Is the SpinWave Robot beeping or giving an error message?
- Yes > Go to SpinWave Light Indication & Errors
- No > Turn power switch off
- The brush may automatically shut off if it is having a hard time spinning on high pile carpet
- It’s intended for use on low pile carpet and bare floors
- Turn the machine over so Brush is facing up
- Remove the Brush guard by pinching the tabs inward
- Pull the Brush up to remove
-
Clean any debris wrapped around the Brush and intake area
-
Check the Brush for damage > The End Caps should spin when turned by hand
- If Brush is damaged > Replace Brush > See Parts & Supplies
-
Reinsert Brush – there are two different end pieces
- Make sure the square-shaped end piece is inserted into the square-shaped port
- If Brush Roll Stuck Error continues when Brush is inserted > Remove Brush > Press Start Button twice
- Is Robot working without the Brush installed?
- Yes > Replace Brush > Go to Parts & Supplies
- No > Please Visit a BISSELL Authorized Service Center or Contact Us
-
Recipient Email
Your Email
Your Name
Was this answer helpful?
Yes
No
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>