My QuickSteamer® Carpet Cleaner has no suction | Support

• Unplug machine

  • Take off the bare floor tool, if attached

  • Remove and empty the collection tank

  • Clean debris from the red rectangular gasket at the motor intake underneath the collection tank

  • Check for suction at the motor intake

    • To test, turn machine on and place hand over opening
    • If no suction, visit a BISSELL Authorized Service Center or Contact Us

  • Check the collection tank for damage

    • If damaged, a new tank needs to be ordered
    • Clean dirt/debris from collection tank
    • Take out and clean the foam filter

  • Remove floor nozzle

    • Recline handle to floor
    • Remove tank
    • Lift upward on metal latch to free the floor nozzle
    • Once metal latch is open, pull outward on upper part of floor nozzle and detach tabs from tab holes
    • Check floor nozzle for damage
    • If damaged, a new nozzle needs to be ordered

  • Re-attach floor nozzle

    • Flip metal latch into open position
    • Insert floor nozzle tabs into front edge of machine (gasket side up)
    • Move upper part of nozzle into position against machine
    • Flip metal latch downward to securely snap into locked position

  • Check for suction by pouring a small amount of water on a hard surface floor

    • Water should be visibly going into the collection tank
    • If still no suction, visit a BISSELL Authorized Service Center or Contact Us

  • Recipient Email

Your Email

Your Name

Was this answer helpful?

Yes
No

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>