My SpotLifter® PowerBrush Corded Portable Carpet Cleaner is not spraying | Support

• Make sure there is water in the solution tank

  • Try priming the machine by squeezing the trigger repeatedly for 1-2 minutes

    • The machine will not spray if you just pull the trigger in and hold it – you must pull the trigger in and release, pull in and release, etc. like a spray bottle
    • If the trigger cannot be squeezed all the way in:
    • Remove tanks from back of machine
    • Try squeezing the trigger with the tank removed – an internal valve could be sticking

  • Make sure the open end of the siphon tube in the solution tank is not pushed into the side of the tank (covering the end of the tube)

    • If it is, push the bend in the siphon tube toward the back of the solution tank

  • Check to see if the siphon tube has become disconnected from the outlet fitting on the inside of the solution tank

    • If it is, a new solution tank will need to be ordered

  • Check to see if air comes through the spray tip by repeatedly squeezing the trigger with solution tank off the machine

    • If not, the spray tip may be clogged – try and unclog the tip with a pin or paper clip

  • Also check that the solution tank is installed properly – should sit flush with no gaps

    • That the black O-ring is present on rear connector to the solution tank
    • If still no spray, please visit a BISSELL Authorized Service Center or Contact Us​​​​​​

  • Recipient Email

Your Email

Your Name

Was this answer helpful?

Yes
No

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>