My Zing®/Easy Vac/Powerforce® Bagged Canister Vacuum has no suction | Support

• ​​​Disconnect hose from canister

  • Turn machine on

  • Place hand over hole on canister to feel for suction

  • • • * If no suction, adjust the variable suction control on the machine

    • Turn the circular knob to adjust suction from minimum to maximum

  • Verify bag is not full and is installed correctly

  • Confirm dust bag compartment door is completely closed

  • Inspect filters

    • Lift bag to access pre-motor filter

    • • *     * Pull filter up and out to remove

    • • *     * Lift post-motor filter cover up on back of machine to access post-motor filter

    • • *     * Clean both filters in warm water with mild detergent

    • Allow to completely air dry (24-48 hours) before reinstalling
    • Ensure black sponge layer of pre-motor filter faces out into the bag compartment
    • Place post-motor filter over the two tabs in the back cover to align correctly

  • If there is suction at the intake, check air-flow regulator on handle

    • Reinstall hose, slide regulator switch forward to expose vent hole on the handle to reduce suction
    • This feature is for instances in which low suction is required

  • Examine hose for clogs

    • Detach hose from machine
    • Carefully insert a broom handle through the hose to clear any debris
    • Inspect hose for damage or cracks
    • If damaged, a new hose will need to be ordered

  • Completely remove floor nozzle hose

    • Look down through the tube, as well as up through the bottom
    • Remove debris

If still no suction, please visit a BISSELL Authorized Service Center or Contact Us

• Recipient Email

Your Email

Your Name

Was this answer helpful?

Yes
No

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>