TurboClean/PowerForce/PowerClean PowerBrush Pet Brush Assembly and First Use Guide | Support
- June 7, 2024
- Bissell
Table of Contents
Assembly:
-
Remove all parts of the machine from box
-
Slide middle handle onto lower body until it clicks
-
Slide upper handle into middle handle until it clicks
-
Put clean water tank on machine and press down until it clicks
Filling Clean Water Tank:
-
Remove clean water tank from machine pulling up on the handle
-
Unscrew the cap
-
Fill with warm tap water to the water line on clean water tank
- Do not use boiling water, do not heat water and/or tank in the microwave, do not put clean water tank in dishwasher
-
Add BISSELL formula to the formula line on clean water tank
- Be sure to use the proper BISSELL formulas in your machine, other formulas may harm the machine and void the warranty
-
Replace cap onto clean water tank
-
Put clean water tank on machine and press down until it clicks
Cleaning Your Carpet
-
Plug in and turn machine on
-
Step on recline pedal below the power switch while pulling back on the handle
-
Make one wet cleaning pass forward and back holding onto the trigger
-
Make one dry pass forward and back with the spray trigger released
-
Repeat until solution being pulled up appears clean
- To speed up dry time continue to perform dry passes until no more solution flows up through the nozzle
-
Empty dirty water tank & refill clean water tank as needed
- For steps on emptying dirty water tank > Go to After Cleaning Care
-
Recipient Email
Your Email
Your Name
Was this answer helpful?
Yes
No
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>