TurboClean/PowerForce/PowerClean PowerBrush Pet Brush After Cleaning Care | Support

• Turn off and unplug machine

  • Remove dirty water tank by pulling out and up on the side latches

    • Lift up on the handle to remove

  • Open rubber tab on top of dirty water tank, pour out dirty water

    • Rinse tank thoroughly
    • Close rubber tab

  • Remove float stack from dirty water tank unscrewing the ring at the bottom of the tank

  • Rinse the float stack under water to remove any debris

    • Ensure that float stack can freely move up and down

  • Let float stack & dirty water tank dry

    • Do not put dirty water tank or float in dishwasher to clean

  • Put float stack back into dirty water tank aligning the arrow on the float with the notch on the tank

    • Twist ring into place to secure float

  • Remove debris from red filter below dirty water tank

  • Grab the top of nozzle and pull away to remove it

  • Rinse nozzle and wipe debris from machine

  • Use a cloth to wipe brush roll cover clean

    • To remove brush roll > Go to Brush Not Turning

  • Let nozzle dry

  • Replace nozzle aligning the top into channel in front of red filter, use both hands to push bottom portion of nozzle into place

  • Return dirty water tank to machine, secure with latches

  • Wrap cord around machine and store in a protected, dry area

  • Recipient Email

Your Email

Your Name

Was this answer helpful?

Yes
No

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>