My Flip-Ease/Vac&Shine® Wet Dry Hard Floor Cleaner is not spraying | Support

• Verify the trigger is being pressed

  • Completely fill the tank with solution & water

  • Confirm the clean water tank is inserted properly by removing the tank and reinserting it

  • Check to see that the gasket is attached to the water tank

    • If it has fallen off, reattach it to the solution/water tank
    • If missing, a new cap and insert will need to be purchased

  • Check the valve on the bottom of the clean water tank to make sure water will come through when the x valve is depressed

    • If water does not come out, the tank may be empty, or the valve may be blocked

  • If blocked, soak the cap and insert in hot tap water until it clears

  • Be sure the handle is installed properly

    • Remove it and reinstall it, ensuring the handle is pushed down all the way
    • If handle re-installation is needed, remove the solution tank and lift the tab located between the two screws and while pulling up on handle

  • Check the umbrella valve on the tank

    • There should be 2 tiny holes, 1 on either side of the rubber tip on the umbrella valve
    • If there’s no holes, a new tank will need to be ordered

  • Check that the solution tube is properly inserted into the floor nozzle

    • If it is not, re-attach the tube

  • The spray tips should be clear & clean

    • If they need to be cleaned, use a paper clip or old toothbrush
    • If the machine still will not spray, please Contact Us

  • Recipient Email

Your Email

Your Name

Was this answer helpful?

Yes
No

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>