ICONpet™ Robotic Vacuum Removing/Replacing Battery | Support
- June 7, 2024
- Bissell
Table of Contents
-
Turn Robot Off
-
Use a Phillips Head screwdriver to remove the two screws from the Battery Cover
-
Remove Battery Cover
-
Gently lift the Battery out of the Robot & rotate it so it sits on the bottom of the Robot
- Rotating the Robot will allow for the Battery to slide out
- It will still be connected by the wires
- Press the Battery connector tab with your finger to disconnect the wires
-
To reinsert the battery, sit the Battery on the bottom of the Robot
- Push the Battery connector down until it clicks and can’t move any farther
- Rotate the Battery into place
- Make sure the wires are in the top position
- Don’t put the Battery into the compartment unless the wires are correctly on top of the connection point
- Don’t force, pinch or twist the wires while reinserting the Battery
- Reattach the Battery cover and secure the two screws
-
Recipient Email
Your Email
Your Name
Was this answer helpful?
Yes
No
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>