ITC 81400 Series Drink Holder Installation Guide
- June 3, 2024
- ITC
Table of Contents
ITC 81400 Series Drink Holder
PARTS/TOOLS NEEDED
- Drink Holders
- Butt Splice Connectors (Not Provided)
- Power Drill
- Hole Saw Bit
INSTALLATION INSTRUCTION
- Determine the installation location and drill a 3-5/8” hole using a hole saw (Note: For part #81427 & 81430 you will need to drill a 4” hole).
- If installing a standard drink holder proceed to step 3. If installing a lit drink holder follow the wiring instructions below
- Only the RGBW version will have the Black/White wire
- If installing an adhesive mount drink holder, simply remove the paper backing and press in place. If installing the screw mount cup holder screw down using the provided screws. If installing the blind mount, tighten screws until the tabs flip out. Replace the decorative ring
VersiColor RGB/RGBW Option
Note: The 81433 USB drink holder has a 2.1A charging speed and will come
standard with DT connectors with the following pin positions:
| Single Color | RGBW |
|---|---|
| Slot 1: BK/BL | Slot 3: BK/WH |
| Slot 2: BK/WH | Slot 4: WH/BL |
| Slot 3: BK/BL |
warranty
For warranty information please visit www.itc-us.com/warranty-return-
policy • Rev B • 03/25/21
3030 Corporate Grove Dr. Hudsonville, MI 49426
Phone: 616.396.1355
itc-us.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>