iBEAM TE-2MPIR Car Camera Installation Guide

: June 7, 2024
: iBEAM

Table of Contents

Part Components
TOOLS REQUIRED
Product Features
Multi-Mounting Options
CAMERA WIRING
- CAMERA WIRING MOUTNING OPTIONS
Specifications
Contact Us
Documents / Resources

iBEAM TE-2MPIR Car Camera Installation Guide

Part Components

Camera
License plate and surface mount
Extension harness (27 FT)
Screws

TOOLS REQUIRED

Wire stripper
Tape
Digital Multi-meter
Cutter

Attention! When testing the aftermarket equipment, ensure that all factory equipment is connected before cycling the key to ignition.

Product Features

Multiple mounts included – license plate and surface mount
Improved power circuit
Can be viewed while driving with compartible monitor
Ability to trigger IRs separetely from the camera’s power
Water resistant – IP67
3 year warranty

Multi-Mounting Options

License plate mount
Surface mount

CAMERA WIRING

Connect the RED wire labeled 12V acc. to the vehicles ignition.
Connect the BLACK wire labeled Ground to chassis ground.

Connect one GREEN wire labeled TRIGGER to the vehicles reverse wire

Applying 12 volts to this wire activates the IRs and Parking lines when in reverse.
This wire can be used if reverse is needed at the opposite end of the vehicle, EX. activating rear camera on an aftermarket radio.
If not using the opposite end of the wire, please cover/cap off the wire so it will not short out and damage the camera.

CAMERA WIRING MOUTNING OPTIONS

Run the extension cable to the front of the vehicle. (Figure A)
Connect the YELLOW RCA to the backup camera or video input of the monitor

Figure A

This camera comes with two mounting options.

Behind license plate mount **(Figure B)

Figure B
**

Surface mount (Figure C)

Figure C

Using the two small phillips head screws on the rear of the camera, the mounts can be switched.

Photo shows camera in both mounting options, 1 camera in box.

Specifications

Sensor

| CMOS II
---|---
Effective Pixel|

648 X 488

Sync Frequency

| NTSC 60 HZ
Resolution|

420 TV Lines

S/N Ratio

| More than 48dB
Current Consumption|

No more than 150mA

Power Supply

| DC 12V +- 10%
Operating Temp|

-22 ~ 176 F

Storage Temp.

| -40 ~ 176 F
Viewing Angle (Dia.)|

170

Water Resistance

| IP67
Min. Illumination|

0.5/F1.2 LUX – 0 LUX IRs on

Contact Us

Having difficulties? We’re here to help.

Contact our Tech Support line at: 386-257-1187
Or via email at: techsupport@metra-autosound.com

Tech Support Hours (Eastern Standard Time)
Monday – Friday: 9:00 AM – 7:00 PM
Saturday: 10:00 AM – 7:00 PM
Sunday: 10:00 AM – 4:00 PM

KNOWLEDGE IS POWER
Enhance your installation and fabrication skills by enrolling in the most recognized and respected mobile electronics school in our industry.
Log onto www.installerinstitute.com or call 800-354-6782 for more information and take steps toward a better tomorrow.

Metra Recommends MECP certified technicians