BLACK DECKER Outdoor Wireless Remote Control Outlets Instruction Manual
- June 7, 2024
- Black Decker
Table of Contents
BLACK DECKER Outdoor Wireless Remote Control Outlets Instruction Manual
Thank you for choosing BLACK+DECKER!
PLEASE READ BEFORE RETURNING THIS PRODUCT FOR ANY REASON.
If you have a question or experience a problem with your BLACK+DECKER
purchase, go to http://www.blackanddeckerelectrical.com
If you can’t find the answer or do not have access to the Internet, call
1-844-746-6688 from 9 a.m. to 5
p.m. EST Mon.-Fri. to speak with an agent.
Please have the catalog number available when you call.
SAVE THIS MANUAL FOR FUTURE REFERENCE.
Important Safety Guideline
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
Definitions: Safety Alert Symbols and Words
This instruction manual uses the following safety alert symbols and words to
alert you to hazardous situations and your risk of personal injury or property
damage.
DANGER: Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.
WARNING: Indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury.
CAUTION: Indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury.
** (Used without word) Indicates a safety related message.
NOTICE: Indicates a practice not related to personal injury which, if not
avoided, may result in property damage.**
WARNING: PLEASE READ THIS INSTRUCTION MANUAL THOROUGHLY AND COMPLETELY BEFORE INSTALLATION & USE. FAILURE TO DO SO COULD CAUSE DAMAGE TO PROPERTY, SERIOUS INJURY OR DEATH, AND VOID YOUR WARRANTY.
- WARNING: Cancer and Reproductive Harm: www.P65Warnings.ca.gov.
Outdoor Wireless Remote Control Outlets
** WARNING:** Before using this outdoor wireless remote control outlet, read and understand the following instructions.
WARNING: Risk of electric shock!
- Keep away from children.
- Do not use in wet locations.
- Fully insert plug.
- When used outdoors, plug into GFCI protected outlet.
WARNING: Danger of explosion if battery is incorrectly replaced. When replacing battery, replace it with the same or equivalent type CR2032. Observe correct polarity (+ and –) when replacing batteries. Do not store or carry batteries so that metal objects can contact exposed battery terminals.
DANGER: DO NOT INGEST BATTERY; CHEMICAL BURN HAZARD. This product
contains a coin/button cell battery. If the coin/button cell battery is
swallowed, it can cause severe internal burns in just 2 hours and can lead to
death.
Keep new and used batteries away from children. If the battery compartment
does not close securely, stop using the product and keep it away from
children.
If you think batteries might have been swallowed or placed inside any part of
the body, seek immediate medical attention.
Remote Battery Replacement:
If operation of the receiver unit becomes erratic, it may be necessary to replace the battery in the hand-held remote unit. To do this, first remove the battery compartment cover. Press the tray release button on the back of the remote. Next, remove the depleted battery and discard according to local ordinances. Be sure to correctly install the new battery. Replace battery compartment cover and test by using it to control the outdoor Remote Outlets.
CAUTION:
- Appliances to be connected to the remote control socket MUST NOT exceed the voltage and current ratings as in “Specifications”.
- Operation is subject to the following two conditions:
- this appliance may not cause harmful interference,
- this appliance must accept any interference received, including interference that may cause undesired operation.
- For both outdoor and indoor use but store indoors when not in use.
- Low transmitter battery may lower the distance between the transmitter and the receiver.
PERFECT FOR LANDSCAPE, HOLIDAY AND SECURITY LIGHTING.
- For both outdoor and indoor use
- Operational range : Max: 100ft (30m)
- Dual grounded outlets – can control two devices
- Easy to install – just plug it in
EASY INSTALLATION:
- One receiver supplied with one transmitter.
- Plug the receiver into a 3-prong outdoor outlet, then plug the lights or device to be switched into the receiver. Make sure that there is power to the outlet that the receiver is plugged into. Let the receiver hang downward so moisture does not accumulate in the outlets.
- The device must be mounted in a vertical position with the receptacle facing downwards and positioned with a minimum vertical length equal to twice the unit. (see image on right side)
- Red indicator light is lit when the outdoor receiver is “ON”.
OPERATION
- Press “ON” on remote to turn receiver ON.
- Press “OFF” on remote to turn receiver OFF.
Control mode and settings.
- Control illustration
Timer Mode
|
Function description
---|---
OFF| Always off
ON| Always on
DUSK-DAWN| Turns power on at dusk，Turns power off at dawn
2 Hrs| Turns power on at dusk，Turns off after 2-hour countdown
4 Hrs| Turns power on at dusk，Turns off after 4-hour countdown
6 Hrs| Turns power on at dusk，Turns off after 6-hour countdown
8 Hrs| Turns power on at dusk，Turns off after 8-hour countdown
2. Mode setting.
Turn the function setting switch until the marking of chosen control mode on
the dial is aligned with the triangle-shaped marking on the timer body.
In ON/OFF mode, the power will always be on or off and the power will not be
affected by the photocell sensor.
The DUSK-DAWN mode uses the photocell sensor to sense if it is light or
dark outside. When the photocell sensor senses darkness, it will automatically
turn the outlets ON. When the photocell sensor senses daylight, it will
automatically turn the outlets OFF.
The 2 Hrs/4 Hrs/6 Hrs/8 Hrs modes also use the photocell sensor to know when
to turn the outlets on and start the countdown of the time chosen. When the
photocell sensor senses darkness, it will automatically turn the outlets ON
(thereby starting the countdown) and will keep them on until the amount of
time that has been chosen is up. Once the time is up, the outlets will
automatically turn OFF.
WARNING: INSTRUCTIONS FOR PROPER USE
- Store indoors when not in use
- Do not immerse into water
- Not for permanent installation. Do not install or use this product for more than a 90-day period per year.
Notice:
Functional Range may be adversely affected by one or more of the following factors:
- orientation of the transmitter or receiver;
- weather, radio frequency interference;
- low transmitter battery and obstructions between the transmitter and receiver.
SPECIFICATIONS
- 125VAC 60Hz 15A 1875W Resistive
- 125VAC 60Hz 10A 1250W Tungsten
- Frequency: 433.92MHz
- Complies with Part 15 of FCC Rule
Outside view and functional unit
Mark Number
| Name|
Function
---|---|---
1
| Power plug| Provides power to the product.
2
| Power socket| Two grounded outlets to provide power.
3
| Indicator light| Indicates power status. When illuminated, power is on to the outlets.
4
| Photocell sensor| Activates timer when dark. NOTICE: for proper operation, do not block. Ensure outlet is not near other light sources.
5
| Control dial| For manual operation and timer settings.
Grounding Instructions
In the event of malfunction or breakdown, grounding provides a path of least resistance for electric current to reduce the risk of electric shock. The remote control outlet must be connected to a cord having an equipment- grounding conductor and a grounding plug. The plug must be plugged into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances.
DANGER: Improper connection of the equipment grounding conductor can result in a risk of electric shock. The conductor with insulation having an outer surface that is green with or without yellow stripes is the equipment grounding conductor. If repair or replacement of the cord or plug is necessary, do not connect the equipment-grounding conductor to a live terminal. Check with a qualified electrician or service person if the grounding instructions are not completely understood, or if in doubt as to whether the remote control outlet is properly grounded. Do not modify the plug connected to the remote control outlet – if it will not fit the outlet, have a proper outlet installed by a qualified electrician.
FOR GROUNDED, CORD-CONNECTED REMOTE CONTROL OUTLET RATED LESS THAN 15A AND INTENDED FOR USE ON A NOMINAL 125V SUPPLY CIRCUIT
The remote control outlet is for use on a nominal 125V circuit, and should be connected to a grounding outlet that looks like that illustrated in sketch a. A temporary adaptor, which looks like the adaptor illustrated in sketch b, may be used to connect this plug to a 2-pole receptacle as shown in sketch b if a properly grounded outlet is not available. The temporary adaptor should be used only until a properly grounded outlet can be installed by a qualified electrician. The green colored rigid ear, lug, and the like, extending from the adaptor must be connected to a permanent ground such as a properly grounded outlet box cover. Whenever the adaptor is used, it must be held in place by the metal screw.
NOTE: IN CANADA, THE USE OF A TEMPORARY ADAPTOR IS NOT PERMITTED BY THE CANADIAN ELECTRICAL CODE. Ensure that the remote control outlet is connected to an outlet having the same configuration as the plug.
1 YEAR LIMITED WARRANTY
IMPORTANT: Proof of Purchase is required to obtain warranty service.
Paragon Group USA Inc. warrants to the original owner that our products will be free from defect in workmanship and material for a period of ONE YEAR from the date of purchase. Should any unit(s) prove to be defective during this period, Paragon Group USA Inc. will be responsible for replacement of the defective unit(s) only. Paragon Group USA Inc. is not responsible for labor charges or any incidental or consequential expenses.
Not Covered – Batteries are not covered by this warranty. Repair service, adjustment and calibration due to misuse, abuse or negligence are not covered by this warranty. Unauthorized service or modification to this product or of any furnished components will void this warranty in its entirety.
This warranty does not include reimbursement for inconvenience, installation, set up time, loss of use, postage, unauthorized service, or other products used in conjunction with BLACK+DECKER products.
Copyright 2021 Black &Decker
BLACK+DECKER and the BLACK+DECKER Logo are trademarks of Stanley Black
Decker, Inc. or an affiliate thereof and are used under license.
Phone: 1-844-746-6688
Website:
www.blackanddeckerelectrical.com
E-mail:
[email protected]
Imported by:
Paragon Group USA,
Englewood, NJ, 07631
USA