Bard Q-TEC Series Heat Pumps Instructions
- June 7, 2024
- Bard
Table of Contents
Bard Q-TEC Series Heat Pumps Instructions
Installation
The plenum box is designed for use with the Q-TECTM Series heat pumps. It is for use in free blow applications.
- Remove the center screw from each top side of the unit (see Figure 1 on page 2).
- Place plenum box on top of Q-TEC unit with the open side down and the grille facing the front of the unit.
- Make sure that the bottom offsets of the plenum box are inside the top of the Q-TEC unit flange as shown in Figure 1. The outside of the plenum box should be flush with the outside of the unit.
- Re-install the center screw in each top side of the Q-TEC unit. These screws will go through the clearance holes on the plenum box and hold it in place.
- Adjust louvers to obtain desired air distribution
NOTE: Height of plenum box is 14″ on all models except QPBS*--8 models which are 8″ tall
Table 1
Model Number | Front Grille Part Number | Side Grille Part Number |
---|---|---|
QPBS42-V | 7051-035 | 7051-046 |
QPBS42-X | 7051-035 | 7051-046 |
QPBS42-X-8 | 7051-073 | 7051-046 |
QPBS42-1 | 7051-035 | 7051-046 |
QPBS42-4 | 7051-035 | 7051-046 |
QPBS42-4-8 | 7051-073 | 7051-046 |
QPBS48-V | 7051-045 | 7051-046 |
QPBS48-X | 7051-045 | 7051-046 |
QPBS48-X-8 | 7051-078 | 7051-046 |
QPBS48-4 | 7051-045 | 7051-046 |
QPBS48-4-8 | 7051-078 | 7051-046 |
QPB42-V | 7051-035 | — |
QPB42-X | 7051-035 | — |
QPB42-1 | 7051-035 | — |
QPB42-4 | 7051-035 | — |
QPB48-V | 7051-045 | — |
QPB48-X | 7051-045 | — |
QPB48-4 | 7051-045 | — |
Bard Manufacturing Company, Inc.
Bryan, Ohio 43506 www.bardhvac.com
Manual: 7960-359I
Supersedes: 7960-359H
Date: 8-19-21
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>