hama 00047564 Satellite Receiver Finder Instruction Manual
- June 3, 2024
- Hama
Table of Contents
00
205359
SAT Finder
SAT Receiver
Operating instruction
Thank you for choosing a Hama product. Take your time and read the following instructions and information completely. Please keep these instructions in a safe place for future reference. If you sell the device, please pass these operating instructions on to the new owner.
Package contents
- Satellite finder with digital display
- These operating instructions
Safety instructions
- Protect the product from moisture.
- Do not leave the SAT finder permanently installed between the SAT dish and receiver.
- When working in the roof area, be aware of safety regulations (danger of falling). If in doubt, contact a qualified expert and do not attempt to install it yourself!
- This product is intended for private, noncommercial use only.
- Use the product only for the intended purpose.
- Protect the product from dirt, moisture and overheating and use it in dry environments only.
- Do not use the product in the immediate vicinity of heaters, other heat sources or in direct sunlight.
- Only use the article under moderate climatic conditions.
- As with all electrical products, this device should be kept out of the reach of children.
- Do not drop the product and do not expose it to any major shocks.
- Do not modify the product in any way. Doing so voids the warranty.
Adjusting the SAT system to the best possible reception with the SAT
Finder
- Disconnect the satellite receiver from the power supply and connect the SAT Finder using an F-plug cable between the LNB and receiver.
- Connect the receiver back to the power supply and select a program slot.
- Set the SAT aerial (SAT dish) roughly to the desired satellites using the protractor and compass. Find the right satellites by turning and swivelling the SAT aerial.
- If the LNB level display is full (see A), turn the level control (B) back anti-clockwise until only 2-3 LEDs light up.
- Now finely adjust the aerial until as many red LEDs (A) light up as possible.
- The “22kHz” LED (C) lights up when the 22 kHz signal is being transmitted.
- Attaching the aerial fastenings with screws.
- ATTENTION: Tightening the screws can change the set value again.
- Check on your receiver whether the desired satellite can be received in the desired quality.
- You can now remove the SAT Finder and reconnect the LNB and receiver.
Warranty disclaimer
Hama GmbH & Co KG assumes no liability and provides no warranty for damage resulting from improper installation/mounting, improper use of the product or from failure to observe the operating instructions and/or safety notes.
Technical data
Frequency range 950-2400 MHz
Hama GmbH & Co KG
86652 Monheim / Germany
Service & Support
www.hama.com
+49 9091 502-0
All listed brands are trademarks of the corresponding companies. Errors and omissions excepted, and subject to technical changes. Our general terms of delivery and payment are applied.
00205359/07.22
Documents / Resources
| hama
00047564 Satellite Receiver
Finder
[pdf] Instruction Manual
00047564, Satellite Receiver Finder, Receiver Finder, Satellite Finder, Finder
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>