behringer Multi-Engine Oscillator Module for Eurorack OLED Oscilloscope Installation Guide

behringer Multi-Engine Oscillator Module for Eurorack OLED Oscilloscope

Controls

1. DISPLAY – Produces a waveform of the audio content for quick visual feedback.
2. USB – Connect a standard USB cable for firmware updates.
3. BANK button – Toggles between Bank A and Bank B models.
4. TIMBRE knob – Function varies depending on the model selected, but generally sweeps from darker to brighter content.
5. HARMONICS knob – Function varies depending on the model selected, but generally adjusts frequency spread or tonal balance.
6. TIMBRE CV LEVEL – Attenuates the voltage received at the Timbre CV input. If the CV input is not patched, and a signal is received at the Trig input, this knob will instead control the amount of modulation from the internal envelope generator.
7. TIMBRE CV – Control the Timbre parameter via external control voltage.
8. OUT 1 – Sends the main processed signal via 3.5 mm TS cable.
9. MODEL jack – Allows model selection to be made remotely via external control voltage.
10. MODEL button – Scrolls through the available models in the currently-active bank.
11. MODEL LEDs – Indicate the current model via red LED for bank A or green LED for bank B.
12. MORPH knob – Function varies depending on the model selected, but generally controls the panning or character.
13. FREQ knob – Covers a range of 8 octaves, but can be narrowed down to 14 semitones.
14. MORPH CV LEVEL – Attenuates the voltage received at the Morph CV input. If the CV input is not patched, and a signal is received at the Trig input, this knob will instead control the amount of modulation from the internal envelope generator.
15. MORPH CV – Control the Morph parameter via external control voltage.
16. OUT 2 – Sends an alternate or variant of the Out 1 signal via 3.5 mm TS cable.
17. TRIG – Performs several functions:
    • Triggers the internal envelope generator.
    • Excites the physical and percussive models.
    • Strikes the internal low-pass gate.
    • Samples and holds the value of the Model CV input.
18. HARMONICS CV – Control the Harmonics parameter via external control voltage.
19. V/OCT – Controls the fundamental frequency relative to the root selected by the Freq knob.
20. FM CV – Control the FM parameter via external control voltage.
21. LEVEL – Opens the internal low-pass gate on the output signal, controlling both output level and brightness. Also triggers an accent when the physical or percussive models are active.
22. FM CV LEVEL – Attenuates the voltage received at the FM CV input.

Name

|

Timbre

---|---
Virtual analog| Square wave: narrow pulse, full square, hardsync formant
Waveshaping| Wavefolder amount
FM 2 operators| Modulation mix
Grains| Formant frequency
Additive| Most prominent harmonic
Chords| Chord inversion/transposition
Speech| Vocal tamber from deep to high
Karplus strong| Brightness and dust noise sensitivity
Super saw| Sets number of waveforms
Wavetable oscillator| Rotates through different waves
Rain| Rain grain density
Noise| Clock frequency
Dust| Particle density
Modal strings| Excitation brightness and dust density
FM drum| LP filter cutoff
Bass drum| Attack brightness and overdrive amount
Snare drum| Balance between different modes of the drum
Hi-hat| HP filter cutoff
Cowbell| Brightness
Toms| Tone

References

• Music Tribe

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>