HYGIPLUS Mini Fridge/Freezer Thermometer Instruction Manual
- June 7, 2024
- HYGIPLUS
Table of Contents
Mini Fridge/Freezer Thermometer
Instruction manual
Model CB891
FEATURES
- Easy installation
- Large and clear digital display
- Out of safety zone alert
- Temperature unit selectable
- Low battery indication
- Low power consumption
SPECIFICATION
Temperature Range
|
-25°C to 50°C / -13°F to 122°F
---|---
Display Accuracy
|
±1°C / ±1.8°F over a full range
Display Resolution
|
0.1° over a full range
Display Reading Update
|
10 seconds
Safety Zone Range
|
0°C to 8°C / 32°F to 46.4°F
Battery
|
3 volt lithium, type CR2032 or equivalent, 1 piece
Product Dimensions
|
42 (H) x 71 (W) x 18 (D) mm
OPERATION
Installation
- Unpack the thermometer with care.
- Press [RESET] button once.
- Peel off display protective sheet.
- Hang the thermometer onto the shelf inside the fridge or pull down the hanger to put the thermometer on the shelf. 5. If the temperature is out of the safety zone of 0°C to 8°C (32°F to 46.4°F), then the * symbol will be flashing to indicate the temperature inside the fridge needs to be adjusted.
Select Temperature Unit
- Unscrew and open the back cover.
- Slide the °C/°F switch to the desired temperature unit.
- Put back the back cover and tighten the screws.
NOTE:
Before opening the back cover for the battery replacement or changing temperature unit, let the thermometer warm up to room temperature. The moisture may be condensed onto the electronic parts and damage the thermometer.
SYMBOLS
Symbol
|
Description
|
Action required
---|---|---
|
Low battery voltage
|
Replace the batteries
LLL
|
1. Sensor open circuit
2. The reading is out of low range (-25°C)
|
1. Return the thermometer for repair
2. Keep the measurement above low range
HHH
|
1. Sensor short circuit
2. The reading is out of high range (50°C)
|
1. Return the thermometer for repair
2. Keep the measurement below high range
COMPLIANCE
Dispose of depleted batteries in accordance with local regulations, within the
EC there are nominated disposal points for batteries.
The WEEE logo on this product or its documentation indicates that the product
must not be disposed of as household waste. To help prevent possible harm to
human health and/or the environment, the product must be disposed of in an
approved and environmentally safe recycling process. For further information
on how to dispose of this product correctly, contact the product supplier, or
the local authority responsible for waste disposal in your area.
HYGIPLAS parts have undergone strict product testing in order to comply with
regulatory standards and specifications set by international, independent, and
federal authorities. HYGIPLAS products have been approved to carry the
following symbol:
All rights reserved. No part of these instructions may be produced or
transmitted in any form or by any means, electronic, mechanical, photocopying,
recording or otherwise, without the prior written
permission of HYGIPLAS. Every effort is made to ensure all details are correct
at the time of going to press, however, HYGIPLAS
reserve the right to change specifications without notice.