ICONpet™ Cordless Vacuum Cleaning Filters | Support
- June 7, 2024
- Bissell
Table of Contents
Maintaining your filters is very important to the function of your vacuum
The steps below provide instruction on how to clean and maintain your Dirt Tank and Filters
- If you are experiencing issues with reduced suction you’ll want to follow the complete list of steps before continuing > Go to No Suction
These steps are considered a part of routine maintenance
-
Remove Dirt Tank from Hand Vac
-
Grip the top portion of tank and pull up to remove the separator (the bottom ring of the separator will activate to “wipe” debris from screen & deposit into tank)
- Clean debris from Separator
- Empty debris from Dirt Tank
-
Pull the Filter Frame from the top of the Separator
- Remove Pre Motor Filter and clear debris (machine should not be used without Filters installed)
- Pre Motor Filter can be rinsed in warm water > Allow to completely air dry (24 – 48 hours) before reinstalling
-
Insert the Filter with tag towards the Filter Frame
-
Insert Filter Frame into Separator > Separator into Dirt Tank
-
Attach Dirt Tank to Hand Vac
- You should hear a click when Tank is secure
-
The Post Motor Filter is located on the back of the Hand Vac
- Press the latch on the back of the Hand Vac > Remove Filter Cover > Pull out Filter
- Post Motor Filter can be rinsed in warm water > Allow to completely air dry (24 – 48 hours) before reinstalling
-
For replacement Filters > Go to Parts & Supplies
-
If you were having suction issues and the steps above did not resolve > Go to Brush/Foot Area
-
Recipient Email
Your Email
Your Name
Was this answer helpful?
Yes
No
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>