onn 12 Series Glass Screen Protector with Built-in Microbial Protection User Guide

Glass Screen Protector
with Built-in
Microbial Protection
Quick Start Guide

Cleaning

Remove the case from your device to avoid interference with the application.

1. Clean the Screen
   Clean the device screen with a wet wipe.

2. Dry the Screen

Dry with the microfiber cloth. Ensure the screen is completely dry before proceeding.

3. Remove Dust
   Use the dust removal sticker to remove any fine particles from the device screen.

Application Tray

1. Apply the Tray
   Snap the orange application tray over the front of your device.
   Tip: Be sure the edge labeled “Top” is at the top of your device.

Screen Protector Application

1. Remove Safety Film
   Using the tab labeled “1-Back”, peel away to expose the adhesive, removing completely.
   Note : Do not touch adhesive on the glass.

2. Place the Screen Protector
   With the adhesive facing your device place the screen protector down into the tray. Align the top edge of the glass and allow the glass to position itself into the tray. ![onn 12 Series Glass Screen Protector with Built-in Microbial

• Place the Screen Protector 1](https://manuals.plus/wp- content/uploads/2021/09/onn-12-Series-Glass-Screen-Protector-with-Built-in- Microbial-Place-the-Screen-Protector-1.jpg)

  3. Attach the Screen
     ProtectorPress firmly down along the center to adhere to the screen protector.

Final Steps

1. Remove the Tray
   Carefully remove the application tray.

2. Remove Air Bubbles
   If there are any air bubbles, remove them by starting from the center and pushing firmly outward toward the edges.
   Note: Small bubbles may dissipate over the next 48  hours.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>