Geek L-B400 Keyless Fingerprint and Touchscreen Digital Door Lock Installation Guide
- June 6, 2024
- GEEK
Table of Contents
Quick Installation Manual
| 
---|---
1, Install the latch, which is adjustable between 60-70mm.| 2, Select the
proper connecting rod and Spindle according to the backset of the door.
| 
3, Route the wire through the spindle and make sure the hole of the spindle
should towards to the internal metal, insert it until you hear a click sound,
then adjust the direction to the “S”(As shown in the picture above).| 4,
Install the connecting rod to double-headed screws, please note that the
oblate side screws should be upwards, round side screws should be down
towards.
| 
5, Insert exterior handle through the latch.| 6, Installed display pictures of
the front door handle.
|
7, Loose the screws (As showed above) to disassemble them into two parts.| 8,
Install the part-1, make sure the “secure lock button” facing upwards as
above; Tidy the exposed wires put it into the hole above to avoid the cable
being crushed; screws the 2 screws; Connecting the cable.
| 
9, Install part-2, and install the batteries, please note the positive and
negative poles of the battery.| 10, Install the battery cover, please note the
button should face upwards.
| Any questions about Geek Smart Lock,
please feel free to contact our customers’ services, we will try our best to
solve your problems.
Email：aftersales@geektechnology.com
The installation was done!|