Geek Chef GCF20A 2 Cup Espresso Coffee Machine User Guide

Table of Contents

Geek Chef GCF20A 2 Cup Espresso Coffee Machine User Guide

Make sure to tear off the sealing tape from the botton of the water tank. (If it has been taken off, please skip
this step)
Make sure the steam wand nozzle is clean and no blocking.
Fill water into the water tank NOT exceed the MAX line. Set up the water tank vertically and align the buckles to the hole on the back of the machine, and press it down to be parallel to the top of the machine.
Plug in the power cord, press power switch to the “on” position, all blue indicator lights will flash as the machine starts heating until the coffee button indicators stay on.
Place a big cup under the steam wand. Rotate the knob to steam position when it is on standby mode.
The Single cup coffee indicator will turn on, press Single cup coffee button to make hot water from the steam wand.
Let the water flow out about 30s-60s, rotate the knob back to the “0” position to stop. This process is let the water flow into the empty pump for the first use.
Place a cup on the drip tray, rotate the knob to the coffee brewing side.
Press the Single or Double cup coffee button to flow out hot water to clean the filter holder or the coffee up. After the water stop flowing, rotate the knob to “0” position.

At the standby mode, press Steam button, the Steam indicator will flash as steam preheating. When the indicator stays on, it means machine is ready to steam.
Prepare a pitcher with about 100ml of cold milk. Insert the steam wand nozzle into the milk about 0.4~0.8 inch. Slowly turn on the steam control knob to control the steam volume.
Rotate the knob to the steam position. The steam indicator will turn on. The machine will start making steam out of steam wand nozzle.

NOTE: During the milk frothing, if lack of water, the machine will produce louder noise and small steam,
please refill in time.
Froth milk in the way moving pitcher round from up to down, after the milk increase in volume by 2 times or the required purpose is reached, turn the knob back to “0” position to stop. Take away the pitcher.
In order to prevent the steam wand nozzle from blocking and make it easier to clean, we suggest you to clean it immediately after frothing milk.
Press and hold the steam wand, pull out the stainless steel sleeve. Clean the steam nozzle with a damp cloth/sponge.

Insert the filter into the filter holder. Fill ground coffee into the filter and press it with the tamp spoon. The ground coffee should be pressed evenly and not too firmly.
Install the filter holder into the machine from “Unlock” to “Lock” position. Place a cup on the drip tray.
Rotate the knob to the coffee brewing side.
After the coffee indicators stop flashing, press Single cup or Double cup coffee button to start brewing
The machine will stop automatically when coffee brewing finished. Rotate the knob back to the “0” position. Enjoy your espresso.