GEPRC GEP-35A-F4 Integrated LC Filter User Manual
- June 6, 2024
- GEPRC
Table of Contents
2~656
GEP-35A-F4
User Manual

SPECS:
Model Name: GEP-35A-F4
MCU: STM32F411
IMU: MPU6000 gyro/accelerometer(SPI)
Firmware target: GEPRCF411
OSD: Betaflight OSD w/ AT7456Ev
Current: YES
OSD: YES
Beeper: YES
LED: YES
USB: micro USB| BEC output: 5V@1A
Intergrated LC Filter
ESC MCU: BB21F16G
Continuous current: 35A
MAX current: 45A (10s)
Input: 2~6S
Supports: Dshot600,Oneshot,Multishot
Current meter: 210
Traget: G_H_30
Size: 32x32mm Board
Installing Hole: 26.5×26.5mm,M2
Weight: 8.3g
---|---
Inistruction Diagram

DJI Digital FPV System
Note: not all combinations are valid. When the flight controller firmware
detects this the serial port configuration will be reset.
Note: Do NOT disable MSP on the first serial port unless you know what
you are doing. You may have to reflash and erase your configuration if you do.



Receiver
Note: not all combinations are valid. When the flight controller firmware
detects this the serial port configuration will be reset.
Note: Do NOT disable MSP on the first serial port unless you know what
you are doing. You may have to reflash and erase your configuration if you do.

FRSKY R-XSR


TBS Crossfire Nano RX


DSM/DSMX

FlySky FSA8S V2

Note: not all combinations are valid. When the flight controller firmware
detects this the serial port configuration will be reset.
Note: Do NOT disable MSP on the first serial port unless you know what
you are doing. You may have to reflash and erase your configuration if you do.

F.Port
set serialnc_halfduplex = ON save


VTX
Note: not all combinations are valid. When the flight controller firmware
detects this the serial port configuration will be reset.
Note: Do NOT disable MSP on the first serial port unless you know what
you are doing. You may have to reflash and erase your configuration if you do.


Note: not all combinations are valid. When the flight controller firmware
detects this the serial port configuration will be reset.
Note: Do NOT disable MSP on the first serial port unless you know what
you are doing. You may have to reflash and erase your configuration if you do.


Camera

LED & Buzzer

GPS
Note: not all combinations are valid. When the flight controller firmware
detects this the serial port configuration will be reset.
Note: Do NOT disable MSP on the first serial port unless you know what
you are doing. You may have to reflash and erase your configuration if you do.


Note: Because the flight control UART port is limited, the GPS can only be connected when the UART1 is free, otherwise the GPS will not work properly!
Official website|
http://www.geprc.com
---|---
Manual| http://geprc.com/support
facebook|
https://www.facebook.com/geprc/
Instagram| https://www.instagram.com/geprc/
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>