GEPRC GP105397 ELRS NanoSE Receiver User Manual

June 6, 2024
GEPRC

GEPRC GP105397 ELRS NanoSE Receiver

GEPRC GP105397 ELRS NanoSE Receiver

Product Introduction

GEPRC ELRS NanoSE Receiver is a new generation remote control system developed based on the ExpressLRS open source project. ExpressLRS sets new standards for
long-range connection, low latency and Maximum refresh rate of 500Hz.

GEPRC ELRS NanoSE Receiver operates at a frequency of 2.4 GHz. Compared with Nano Receiver, NanoSE Receiver uses an Integrated SMD ceramic antenna, which further reduces its size while ensuring signal reception, making it more suitable for use on drones with limited space and light weight.

Specifications

Size: 12.1mm*10.4mm
Weight: 0.4g
Chips : ESP8285, SX1281
Frequency band: 2.4GHz ISM
Refresh rate: 25Hz-500Hz
Input voltage: 5V
Antenna: Integrated SMD Ceramic Antenna

LED Status indication

LED Status Meaning
Solide on Connection established
Flash slowly No Tx signal
Flash qucikly WIFI mode
Flash double quickly Binding status

NanoSE Receiver diagram

NanoSE Receiver diagram

Instructions

ELRS NanoSE Receiver and FC connection diagram:

Instructions

Open Betaflight Configurator, go to “Ports”tab and enable the corresponding UART as a Serial Rx (e.g. UART2 as shown below). Save and restart.

Instructions 1

On the“Configuration” tab, click on“Serial-based receiver” on the“Receiver” panel, and select “CRSF”.

Instructions 2

Binding

  1. The receiver is powered on and off for three consecutive times (within an interval of 1 second);
  2. Receiver’s LED doing double flashing, indicating that the receiver has entered the binding mode;
  3. Make the RF Tx module or radio transmitter enter binding status. Once the LED status changes to solid light, the binding is successful.

About ELRS
ExpressLRS project is being constantly updated – the contents of this manual cannot be kept up-to-date in time.
For more information, please visit the ELRS Project official. github page: https://github.com/ExpressLRS/ExpressLRS

Product list

  • 1 x NanoSE receiver
  • 2 x heat shrink tube
  • 4 x silicone cable(black, red, yellow, green)
  • 1 x pin (4pin)
  • 1 x Instruction manual
  • 1 x Sticker

Contact
Website: https://geprc.com/

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals