MOTOROLA SOLUTIONS PMLN8086 Over-the-Head Headset User Manual
- June 6, 2024
- Motorola Solutions
Table of Contents
SOLUTIONS
ATTENTION
Before using this product, read the RF Energy Exposure and Product Safety Guide that ships with the radio which contains instructions for safe usage and RF energy awareness and control for compliance with applicable standards and regulations.
ACOUSTIC SAFETY
Exposure to loud noises from any source for extended periods of time may temporarily or permanently affect your hearing. The louder the radio’s volume, the less time is required before your hearing can be affected. Hearing damage from loud noises is sometimes undetectable at first and can have a cumulative effect. To protect your hearing:
- Use the lowest volume necessary to do your job.
- Increase the volume only if you are in noisy surroundings.
- Reduce the volume before connecting the headset or earpiece.
- Limit the amount of time you use headsets or earpieces at high volume.
- When using the radio without a headset or earpiece, do not place the radio’s speaker directly against your ear.
- If you experience hearing discomfort, ringing in your ears, or speech that is muffled, you should stop listening to your radio through your headset or earpiece, and have your hearing checked by your doctor.
Refer to the Approval manual that ships with the radio for information on intrinsic and/or non-incendive safety certification.
HEADSET OPERATION
- Turn off the radio. Connect the headset to the radio, making sure not to over-tighten the mounting screw (where applicable).
- Turn on the radio, making sure not to set the volume level of the radio too loud.
- Adjust the head strap for the best fit/comfort.
- Position the boom mic 1/2 to 3/4 inches from the user’s mouth.
- Press PTT to transmit audio from the headset microphone. Release PTT to receive audio into headset speakers.
NOTE : On some radio models, the Voice Over Activation (VOX) functionality is activated by radio settings. Refer to the radio Customer Programming Software (CPS) for configuration.
REPLACEMENT PARTS
No.
| Item|
Motorola Solutions Part Number
---|---|---
1| Microphone Windscreen with Retaining 0-Ring (5pcs per pack)| AY000310A01
2| Gel Ear Seal with Mesh and 0-Ring (2pcs per pack)| AY000311A01
3| Left Boom Microphone Right Boom Microphone| AY000312A01
AY000313A01
CABLE MANAGEMENT
To ensure
optimum range and user experience, it is recommended to avoid crossing the
accessory cable with the radio antenna.
WARRANTY SUPPORT
Motorola Solutions offers a warranty for your accessory. Refer to your
Motorola
Solutions dealer or point-of-purchase for detailed information.
NOTE : Warranty is void after customer replacement of any parts other than replacement parts listed.
NOTES
Over-the-Head Headset PMLN8086
MN006607A01-AB
MOTOROLA, MOTO, MOTOROLA SOLUTIONS, and the Stylized M Logo are trademarks or
registered trademarks of Motorola Trademark Holdings, LLC and are used under
license. All other trademarks are the property of their respective owners.
© 2020 Motorola Solutions, Inc. All rights reserved.
Refer to manual MN006814A01 for other languages:
https://learning.motorolasolutions.com/
EU Contact: Motorola Solutions, Czerwone Maki 82, 30-392 Krakow, Poland
Printed in
