IMOU IPC-B26EP IP WiFi Compact Camera User Guide
- June 6, 2024
- imou
Table of Contents
**IMOU IPC-B26EP IP WiFi Compact Camera User Guide
**
Welcome
Thank you for choosing IMOU. We are devoted to providing you easy smart home
products. If you have problems using the product, please contact our service
team before returning your product.
Our service mail:
service.global@imoulife.com
Frequently asked questions can be found at
imoulife.com/support/help
Package content
-
Camera ×1
-
Quick Start Guide ×1
-
Power Adapter ×1
-
Bracket ×1
-
Positioning Map ×1
-
Power Cable ×1
-
Screw Package ×1
-
Battery ×1
-
Hub ×1
Camera introduction
Note:
Press the SYNC button to pair with the base station.
Press and hold the SYNC button for 8s to reset the camera.
Installing Battery
The pattern of the LED indicator is included in the following table.
LED Indicator Status
|
Device Status
---|---
off
| Sleeping mode Run out of battery
Green light on|
Alarm is triggered
Instructed to wake
Green light flashing
| Reconnecting Wi-Fi
Green light quick flashing|
Waiting for pairing with the base station
Green light stay on for 10 s, then off
| Pairing succeeded
Red light stay on for 10 s, then off
|
Pairing timeout
Red light stay on for 1 s, then off|
Reset completed
Hub
**Tips
** To ensure the best possible wireless performance, please make sure there
are no obstacles and electromagnetic interference between the camera and hub.
Pairing with the Hub
-
Press the SYNC button, and then the indicator on the base station flashes with white light.
-
Press the SYNC button, and then the indicator on the camera flashes with green light.
-
The system indicator on the Hub stays on with white light for 10 s, and then off.
The indicator on the camera stays on with green light for 10 s, and then off.
Note: You can pair six cameras at most with one Hub, and pair one camera
at a time.
Keep the distance of the Hub and the camera within 30 cm (12 inches)during
pairing.
Installing Camera
Pairing mit dem Hub
Troubleshooting
Problem
|
Solution
---|---
Cannot set up camera
| • Ensure your mobile device and the camera are within range of your Wi-Fi router.
• Ensure the LED indicator on the camera isflashing green before beginning setup.
The APP says “Failed to configure device network”
| • Reset your Camera and connect it again.
• Some cameras only support 2.4GHz, while some routers have dual band, 2.4G/5G. Make sure you are connecting 2.4GHz only.
The app says “Failed to bind”
| The camera is already connected to Wi-Fi, but the router is:
• Not connected to Internet
• Poor network status
• The Wi-Fi signal is not stable due to obstacles or electronic interference
No picture / signal
| • Ensure the LED indicator on the camera is flashing steady green. See ‘LED Status’ section for details if otherwise.
• Ensure the camera is properly connected to power using the included USB power adapter.
• Try repositioning the camera, router, or both to improve signal strength.
Picture is not clear
| • Check the camera lens for dirt, dust, spider webs. Clean the lens with a soft, clean cloth.
• Remove the vinyl cover on the camera lens.
No audio
| • Ensure audio function on camera is turned on.
• Ensure audio is turned up on viewing device.
Phone is not reading QR code
| • Clean the camera lens of your Smartphone
• Ensure that there is enough light on the QR code
• Don’t hold the QR code too close to the camera
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>