UMAX City Racer 36 Electric Scooter User Manual

: June 6, 2024
: UMAX

City Racer 36

Electric Scooter

electric scooter

scooter parts

current speed

Power on

Long press the power button to turn on and off the scooter.

Speed limitation

Short press the function key to cycle through speed limitation settings. Slow speed (10 km/h) – no indicator light, medium speed (20 km/h) – white indicator light, maximum speed (25 km/h) – red indicator light.

Front light

Press the function key twice to turn on and off the front light.

Throttle

Stand up on the scooter with one leg and push the scooter with your other leg. Press the throttle button and motor will engage. If your speed is too low, pressing the throttle will do nothing.

Cruise mode

The cruise mode is automatically enabled after riding at the same speed for 6 second. The disable the cruise mode, press the brake or throttle button.

First use

Press down the rear wheel fender and pull up the main pole.
Fasten the main pole lock.
Fasten the main pole lock.
Tighten handlebars.
Adjust the screw to prevent shaking of the main pole.

fix break
rear wheel
main pole

Folding

Loosen the fixing ring.
Open the lock of main pole.
Fold the main pole and close the lock.
Push the pole down to put the hook inside the fender.

folding parts
hold folding

Installing Battery

Insert the battery into the main pole.
Push it down until the lock latch is tightened.

battery installation

Removing Battery

Pull out the lock latch on the battery case.
Push the battery up from the bottom.
Pull out the battery.

removing battery

Charging

Open the rubber charging port cover and check that the charging port is clean and dry. First, plug the charger into a wall socket (indicator on the charger lights up in green color). Then, connect the charger to the charging port on the scooter. The indicator on the charger lights up in red color during charging. The indicator lights up in green color when charging is finished. After charging, close the rubber charging port cover to prevent dust and water from getting into the port and damaging the battery.

Riding

wear helmet

Wear helmet and other protective equipment when you ride the scooter. Before riding the scooter, check that both wheels are fully inflated. Press the power button for 2 seconds to turn on the scooter.
Place one foot on the scooter and push with your other leg. Balance both feet on the scooter. Press the throttle button to engage the motor.

Keep holding the throttle button to speed up. Press the brake to slow down and stop. After the scooter stops moving, you can get off.

Riding Safety

Always wear helmet and wearing-helmet

Do not ride the scooter during rain.

Maximum load 100kg.

ride safety
Do not ride the scooter on roads with cars.

Do not ride the scooter after drinking alcohol.

no phone riding Do not use your phone or listen to music when riding the scooter.

The scooter is designed for riders 14-60 years old. Pregnant woman should not ride the scooter.

Do not ride the scooter in dangerous areas, where you can encounter explosions or fire.

careful riding Be careful when riding on wet, icy, muddy, slippery roads, sandstone roads, slopes (angle > 15°). Watch out for roadblocks, stairs, and dark areas.

Battery Safety Information

Do not use the battery if there is any leak, odor, or excessive heat. Do not touch anything leaking from the battery. Unplug the charger before installing the battery or riding the scooter. The working and charging temperature of the battery is between 0°C and 35°C. Do not charge or use the battery outside of these temperatures. The battery contains dangerous substances. Do not open the battery. Do not insert anything into the battery. Do not charge an over- discharged battery. Only use the original charger to charge the battery.

Maintenance

Disconnect the charger and turn off the scooter before any maintenance. Wipe the scooter with a soft cloth to clean it. Do not put lubricating oil on the wheel bearing. Do not soak the scooter in liquid. Do not use water cannon to clean the scooter.

Storage

Fully charge the scooter before storage to prevent overdischarge of the battery. Charge the scooter at least once every three months. The storage temperature is between -10°C and 35°C. Do not charge the scooter at low temperature, place it indoors with temperature at least 10°C and charge it after the scooter warms up. Keep the scooter at dry environment.

Service Center

+420 800 118 629 servis@umax.cz Umax Czech a.s., Kolbenova 962/27e, 198 00, Praha 9, Czech Republic Manufacturer Gyártó Umax Czech a.s., Kolbenova 962/27e, 198 00, Praha 9, Czech Republic Web www.umax.cz Youtube UMAX Czech Republic Facebook Umax.cz Instagram umax_czech

Importer here by declares that this wireless device is in compliance with the essential requirements and other relevant provisions of the R&TTE Directive and Radio Equipment Directive 2014/53/EU, as applicable. A copy of the EU Declaration of Conformity is available at www.umax.cz.