hama 00054677 Back Cover Film Instruction Manual
- June 6, 2024
- Hama
Table of Contents
hama 00054677 Back Cover Film
Thank you for choosing the Hama screen protector. For optimal results, this screen protector must be attached carefully and correctly. Take your time and read the following instructions and information completely. Then proceed step by step.
Operating instruction
Explanation of Warning Symbols and Notes
Warning: This symbol is used to indicate safety instructions or to draw
your attention to specific hazards and risks.
Note: This symbol is used to indicate additional information or important
notes.
Package Contents
Screen protector(s)
- Microfibre cloth
- Installation aid (optional)
- Scraper card (optional)
- These installation instructions
Note: The actual screen protectors come delivered with one or two sheets of backing film. Although there may be scratches present on the backing film, this does not negatively affect the actual screen protector. Only remove this backing film when instructed to do so by these operating instructions.
Installation Requirements and Preparations
- Select a room with as little dust as possible to perform the installation (for instance the bathroom).
- Use a clean, level and flat surface with no cloth covering as a work surface.
- Lay out the microfibre cloth, the purchased screen protector, the included scraper (optional) and the installation aid (optional).
- Check that the screen protector is positioned correctly. To check, place the protector on your screen and determine the correct position for subsequent installation. Openings for speakers, microphones, cameras, etc. must be kept free.
- Before attaching the protector, clean the screen as thoroughly as possible. Any contamination on the screen, for example dust, finger prints or lint will be visible after the screen protector is attached and may negatively affect the adhesion.
Note: A microfibre cloth which has been lightly moistened with lukewarm water is sufficient for the cleaning.
Warning: Do not clean using paper towels, kitchen towels or abrasive cleaning agents under any circumstances. This will scratch or damage the surface of the screen!
Note: Once you have thoroughly cleaned the screen, check whether the screen protector has been delivered with one or two sheets of backing film.
Attaching the Protector
-
Remove the first sheet of backing film from the adhesive side (1) of the actual screen protector halfway. Pull tabs are marked on the backing film for this purpose.
-
As you proceed, be sure not to bend the screen protector.
-
Do not touch any exposed areas on the adhesive side of the screen protector.
-
Place the screen protector on the edge of the screen and check again that it is positioned correctly relative to the rest of the screen.
-
If the screen protector is crooked, you can pull it off and repeat the procedure.
-
Using light, even pressure, press the screen protector onto the display using a microfibre cloth or the optional scraper. Remove the backing film (1) evenly. Alternatively, cover a sturdy piece of cardboard, for example the packaging from Hama, with a microfibre cloth and use this as a scraper.
-
Remove the second sheet of backing film (optional).
Press any remaining air bubbles from the middle outwards using a microfibre cloth. -
Finally, clean the protector with a microfibre cloth.
Note: It takes the protector 2-3 days to completely flatten on the screen. Most air pockets will disappear after this time. However, if these air bubbles are caused by dust, repeat the installation procedure after a thorough cleaning. Use strips of conventional clear cellophane tape as an installation aid so as not to touch the adhesive side of the protector.
Service and Support
Please contact Hama Product Consulting if you have any questions about this
product.
Hotline: +49 9091 502-115 (German/English)
Further support information can be found here:
www.hama.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>