hama Smart Air Purifier Instruction Manual

: June 6, 2024
: Hama

hama Smart Air Purifier

Overview

Controls and displays

Display and operating display
The illuminated ring visually indicates the indoor air quality
Green: good room air;
Yellow: normal room air;
Red: bad room air.
● Reminder function for filter change: when the air purifier detects that the filter has reached the saturation level, the operation indicator flashes red continuously. The filter should then be replaced to ensure sufficient air purification.
● With daily use, the combi-filter should be used up after approx. 6 – 12 months.
● The filter is not washable.
● An unpleasant odour during operation may indicate that filtered substances are decomposing in the filter (e.g. bacteria) and it needs to be replaced or ventilated in the sun.
● Vacuum the filter and the inner housing every 1 to 2 months to remove coarse dirt. Then place the filter outdoors in direct sunlight for approx. 3 hours to dry it and eliminate any bacteria, viruses etc. that may be present through the UV rays.
● The filter can then possibly be reused. The filter must be replaced after 1 year at the latest. On the one hand, there is a risk that it will no longer completely remove the particles mentioned from the air or that the pollutant particles already in the filter will be released again. The activated charcoal also loses its effect when unpacked.
● After replacing the filter, you must press the ON/OFF button (8) for approx. 7 seconds to cancel the alarm.
Air outlet opening
Front panel
Air intake opening
Filter unit
Base plate
ON/OFF button:
Touch the icon to switch on the device. The buzzer sounds once. Blue light and the low wind speed indicator L light up. If you touch the button again, the buzzer sounds once and the device switches off.| Note
The device records the working modes when you switch it off if you do not unplug it. If, for example, automatic was selected – the device starts again with automatic.
---|---
Timer button:
When the device is switched on:
Running time of 2-4-8hours or WLAN control preselectable. After the selected hours have elapsed, the device stops operating. On the WLAN setting, the device is on standby and waiting for commands via the APP control.
See also the section on WLAN/APP operation
Speed button:
When the device is switched on:
Fan speed level L-M-H-Auto.
The buzzer sounds each time the switch is made. An LED next to it indicates the selected speed.
L Low speed
M Medium speed
H High speed
Auto: the device regulates the fan speed independently according to the air quality. The illuminated ring (2) shows the air quality in colour.
If the humidity in the room is very high, condensation can form on the sensor and negatively affect the display and cause switching back and forth in automatic mode. In this case, use the air purifier with a manual speed setting.
Light button:
When the device is switched on:
Press once, the buzzer sounds once and the LED light (2) changes to soft mode. Press again to switch the light to standard mode. Press again to switch off the light.
Control lamps. An LED lights up next to the symbols to check the settings.

| Important information – Quick-reference guide

This quick-reference guide contains the most important basic information, such as safety instructions and the steps necessary to operate the product.
To help protect the environmental and conserve valuable raw materials, Hama does not issue a printed manual and instead makes this available exclusively as a PDF download. The full text of the manual is available at the following internet address:www.hama.com - > 00186437 -> Downloads
Save the manual on your computer for reference and print them out if possible.

---|---

Thank you for choosing a Hama product.
Take your time and read the following instructions and information completely.
Please keep these instructions in a safe place for future reference. If you sell the device, please pass these operating instructions on to the new owner.

Explanation of warning symbols and notes

| Risk of electric shock
This symbol indicates a risk of electric shock from touching product parts carrying hazardous voltage.
---|---
| Warning
This symbol is used to indicate safety instructions or to draw your attention to specific hazards and risks.
---|---
| Note
This symbol is used to indicate additional information or important notes.
---|---

Package contents

1 air purifier
1 combi filter
These operating instructions

Safety instructions

The product is intended for private, non-commercial use only.
The product is intended only for use inside buildings.
Use the product only for the intended purpose.
Protect the product from dirt, moisture and overheating and use it in dry rooms only.
Always pull directly on the plug when disconnecting the cable, never on the cable itself.
Do not use the product in the immediate vicinity of heaters, other heat sources or in direct sunlight.
As with all electrical products, this device should be kept out of the reach of children.
Do not operate the product outside the power limits specified in the technical data.
Do not use the product in areas in which electronic products are not permitted.
Do not use the product in a damp environment and avoid splashing water.
Do not place the product near interference fields, metal frames, computers, TVs, etc. Electronic devices and window frames can negatively affect the product’s functionality.
Do not drop the product and do not expose it to any major shocks.
Do not modify the product in any way. Doing so voids the warranty.
Keep the packaging material out of the reach of children due to the risk of suffocation.
Dispose of packaging material immediately in accordance with the locally applicable disposal regulations.
Route all cables so that there is no risk of tripping.
Do not bend or crush the cable.
Only use the article under moderate climatic conditions.
Do not spray flammable materials, such as insecticides or fragrances, around or into the device. Also, do not use it to spread these or other substances.
Do not operate the device in places contaminated by chemical agents, poisons, smoke, oil or explosive and other gases.
Do not use the device near gas-fired devices, such as gas boilers, heaters or open fireplaces.
The device cannot be used as a cleaning device after fire or chemical accidents.
Do not cover the ventilation openings of the product and ensure sufficient ventilation of the product to avoid overheating! Fire hazard!
The lateral distance to other objects should be at least 20cm and above the device at least 30cm.
Do not place any objects on the device and never use it as a resting surface.
Do not insert any objects into the device through the air inlet or outlet.
The air purifier is not a substitute for regular ventilation or vacuum cleaning.
Do not use the device as a substitute for an extractor hood or other ventilation during cooking.
Only set up the device in a dry, stable, level and horizontal location.
Do not move the device during operation and avoid all shocks or impacts to the device.
Disconnect the device from the mains before changing its location.
Disconnect the product from the mains before changing filters, cleaning and maintenance work.
Do not sit or stand on the device.
Only use original Hama filters, item No. 00186440, as these guarantee the appropriate filter effects and do not cause any damage due to incorrect air resistance.
Dispose of used filters with household waste.
The device cannot remove carbon monoxide (CO) or radon (Rn) from the air.
The device is intended for domestic use only under normal operating conditions. Do not operate if there are strongly fluctuating temperature differences.
Do not use it in a humid environment or in rooms with high ambient temperature or humidity, e.g. in the bathroom, toilet or kitchen.
Close windows and doors when operating the device to effectively clean the room air

| Risk of electric shock

Do not open the device or continue to operate it if it becomes damaged.
Do not use the product if the AC adapter, the adapter cable or the mains cable are damaged.
Do not attempt to service or repair the product yourself. Leave any and all service work to qualified experts.

---|---

The principle of air purification

A fan in the device draws in room air via the air inlets (5).
The pre-filter is located at the top of the filter system for the initial filtration of impurities. Larger particles such as dandruff, hair and dust are filtered out.
Afterwards, the sucked-in air flows through the Hepa 13 filter. The abbreviation HEPA stands for “High Efficiency Particulate Air”. The HEPA filter consists of a very fine fibre material. It has the ability to capture the smallest particles down to a size of between 0.1 to 0.3 μm, achieving a separation efficiency of 99.95%. Thus, it can remove bacteria (0.6 to 1.0 μm); filter fine dust (0.1 – 10 μm) and pollen (10 – 100 μm) from the air.
The air then flows through an activated charcoal filter. It filters out formaldehyde, benzene, other gases and unpleasant odours. Activated charcoal has an excellent absorption capacity. It can deodorise, dehumidify and in some cases trap viruses and have a sterilising effect.
The filtered air is discharged into the room at the air outlet.

Start-up and operation

Inserting/changing the filter

| Warning

Make sure that the product is disconnected from the mains.
Since the filter contains all the collected pollutants, it should only be changed outdoors and with appropriate care against contact contamination (gloves/respiratory protection).

---|---

The filter must be inserted before the first start-up.

To do this, proceed as follows:

Lay the air purifier on its side.
Turn the base plate a quarter turn anticlockwise. The base plate can be removed. (Fig. 1)
Remove the used filter, if any, and dispose of it in your household waste. (Fig. 2)
Remove the new filter from the protective packaging (Fig. 3) and insert it into the device. (Fig. 4)
Now reinsert the base plate into the latching lugs. Turn the base plate clockwise to tighten. (Fig. 5)

Switching the device on/off

| Warning

Only operate the product from an approved socket that is connected to the public power supply. The socket must be installed close to the product and must be easily accessible.
Disconnect the product from the power supply using the On/Off switch – if this is not available, unplug the power cord from the socket.
If using a multi-socket power strip, make sure that the total power consumption of all connected devices does not exceed the power strip’s maximum throughput rating.
If you will not be using the product for a prolonged period, disconnect it from mains power.

---|---

Connect the mains lead on the air filter to a properly installed socket.
Switch the air filter on/off using the ON/OFF button (8).

Start-up and operation

Here’s how easy it is – Download the app:

Download the Hama Smart Home (Solution) APP from the Apple App Store or Google Play Store.
Open the Hama Smart Home (Solution) app.
The first time you use the app, you need to register and create a new account. If you already have an account, log in with your access details.
First you need to incorporate the fan into the app. To do this, connect the fan to a properly installed socket.
Press and hold the OSC button for around 5 seconds. The WiFi symbol now starts to flash quickly.
In the app, click on the “+” in the top right-hand corner and select “Fan” as the category.
Now enter the name of your WiFi network and the password and confirm your entries with NEXT.
Ensure that the fan is connected to the power supply and that the WiFi symbol is flashing. Check the box during the next step and click Next.
If the connection is successful, the app confirms that the fan has been incorporated. You can now assign it a different name if you wish.
Click Finish to end the process.
You can now rename your device, adjust it and configure it.

| Note – Pairing restart
Press and hold the OSC button on the top of the fan for around 5 seconds until the WiFi display flashes quickly
---|---

Care and maintenance

| Note
Disconnect the device from the mains before cleaning and during prolonged periods of non-use.
---|---

Only clean this product with a slightly damp, lint-free cloth and do not use aggressive cleaning agents.
Ensure that no water is able to enter the product.
* See also the “Replace Filter” section for detailed cleaning instructions

Warranty disclaimer

Hama GmbH & Co KG assumes no liability and provides no warranty for damage resulting from improper installation/mounting, improper use of the product or from failure to observe the operating instructions and/or safety notes.

Technical data

Recycling information

Note on environmental protection:
Following the implementation of European Directive 2012/19/
EU and 2006/66/EU into the national legal systems, the following applies:
Electrical and electronic devices as well as batteries must not be disposed of with household waste. Consumers are obliged by law to return electrical and electronic devices as well as batteries to the designated public collection points or to the point of sale at the end of their service lives. Detailed information on this topic is defined in the national laws of the respective country. This presence of the above symbol on the product, operating instructions or package indicates that the product is subject to these regulations. By recycling, reusing the materials or other forms of utilising old devices/batteries, you are making an important contribution to protecting our environment

RF exposure information

This device complies with the EU requirements for limiting the exposure of the general public to electromagnetic fields by means of health protection.
The device complies with RF specifications provided it is used 20 cm away from the body.

Declaration of conformity

Hama GmbH & Co KG hereby declares that the radio equipment type [00186437] is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following Internet address:
www.hama.com-> 00186437->Downloads.

Frequency band(s)	2.4 GHz
Maximum radio-frequency power transmitted	< 100 mW

Specifications according to EU Directive 2019/1782

Hama GmbH & Co KG
86652 Monheim/ Germany

Service & Support

www.hama.com
+49 9091 502-0

All listed brands are trademarks of the corresponding companies. Errors and omissions excepted, and subject to technical changes. Our general terms of delivery and payment are applied.