hama Car Smartphone Holder Instructions

: June 6, 2024
: Hama

Table of Contents

Explanation of warning symbols and notes
Package contents
Safety instructions
Holder installation
Use the magnetic pads to apply/insert
Warranty Disclaimer
Read User Manual Online (PDF format)
Download This Manual (PDF format)

hama Car Smartphone Holder

Car-Smartphone-Holder

Thank you for choosing a Hama product. Take your time and read the following instructions and information completely. Please keep these instructions in a safe place for future reference. If you sell the device, please pass these operating instructions on to the new owner.

Explanation of warning symbols and notes

Warning
This symbol is used to indicate safety instructions or to draw your attention to specific hazards and risks.

Note
This symbol is used to indicate additional information or important notes.

Package contents

hama-Car-Smartphone-Holder-Package-Content

Magnetic holder
These operating instructions

Safety instructions

Use the product for its intended purpose only.
Protect the product from dirt, moisture and overheating, and only use it in a dry environment.
When using this product, observe the applicable local traffic laws and regulations.
Passengers must always have their seatbelts fastened so that abrupt movements of the vehicle (braking, steering) or an accident will not cause them to collide with the product and injure themselves.
Dispose of packaging material immediately according to locally applicable regulations.
Do not modify the product in any way. Doing so voids the warranty.

Warning

Take care that components such as airbags, safety areas, controls, instruments, etc. and visibility are not blocked or restricted.
Do not allow yourself to be distracted by the product, for example when driving a vehicle or operating sports equipment. Always pay attention to the surrounding traffic and your environment.

Holder installation

Note

Before mounting the holder, check the installation options in your vehicle. If in doubt, consult the manual for your vehicle or contact the manufacturer.
Before setting a device in the holder, check that the panels are sturdy enough to bear the weight. We recommend against using this model for terminal devices heavier than 300 g.
Never apply force when using the product or during installation.
Carefully push the ventilation grille clamp onto the open panels of the ventilation grille until it locks into place
To remove the holder, carefully pull it out of the ventilation grille.

Use the magnetic pads to apply/insert

Note - Adhesive surface

Ensure that the mounting surface to which the adhesive pad is to attach (such as the back of a mobile phone, GPS navigation system, etc.) is free of dust and grease. Use a suitable cleaning agent from a specialised dealer to clean the surface.
We cannot guarantee that residue will not be left on the mounting surface after the adhesive pad is removed.
Remove the protective foil from the adhesive side of the round magnetic pad and press it onto the rear of the mobile phone for a few seconds.
The rectangular magnetic pad can simply be inserted between the protective cover and the back of the mobile phone.
Please note that a thick protective cover may reduce the effectiveness of the magnetic clasp.
Please note that dust and dirt that gets between the mobile phone and the magnetic pad may cause scratches.
Please note that the magnetic pad inside is manufactured out of metal and therefore may impair the transmitting and receiving

Warranty Disclaimer

Hama GmbH & Co KG assumes no liability and provides no warranty for damage resulting from improper installation/mounting, improper use of the product or from failure to observe the operating instructions and/or safety notes.

All listed brands are trademarks of the corresponding companies. Errors and omissions excepted, and subject to technical changes. Our general terms of delivery and payment are applied.