hama SAT Finder Instructions
- June 6, 2024
- Hama
Table of Contents
hama SAT Finder Instructions
SAT Finder
Operating instruction
1 .Safety instruction s
- Protect the product from moisture.
- Do not leave the SAT finder permanently installed between the SAT dish and the receiver.
- Take proper safety precautions when working on the roof (risk of falling). If in doubt, contact a qualified technician and do not attempt to mount the product yourself!
2. Adjusting the SAT system for the best possible reception using the
SAT finder
- Disconnect the SAT receiver from the power supply and connect the SAT finder as shown with the short F cable between the LNB and receiver.
- Reconnect the receiver to the power supply, select a channel.
- Adjust the sensitivity controller (1) until the level jumps.
- Using a protractor and compass, roughly adjust the SAT antenna (SAT dish) accordingto the desired satellites. Search for the proper satellite by turning and panning the SAT antenna.
- The stronger the incoming SAT signal, the higher the measurement tone that sounds; the level (needle) on the signal strength display (2) also rises from weak “1” to medium to strong “10”.
- If the level reaches the maximum of “10”, turn down the sensitivity controller (1) until the level shown is reduced.
- Now finely tune the antenna to get as close to the maximum value of “10” as possible.
- Tighten the antenna fasteners.
- WARNING: The set value can change again when the screws are tightened.
- On your receiver, check if the desired satellite can now be received.
- You can now remove the SAT finder and reconnect the LNB and the receiver.
All listed brands are trademarks of the corresponding companies. Errors and
omissions excepted, and
subject to technical changes. Our general terms of delivery and payment are
applied.
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>