Power Dynamics PDVC100 100V Volume Control Instruction Manual
- June 6, 2024
- Power Dynamics
Table of Contents
PDVC100 100V Vol.Control 100W 2×4″
Ref. nr.: 952.575
INSTRUCTION MANUAL
V1.0
Congratulations to the purchase of this Power Dynamics product. Please read
this manual thoroughly prior to using the unit in order to benefit fully from
all features.
Read the manual prior to using the unit. Follow the instructions in order not
to invalidate the warranty. Take all precautions to avoid fire and/or
electrical shock. Repairs must only be carried out by a qualified technician
in order to avoid electrical shock.
Keep the manual for future reference.
– Prior to using the unit, please ask for advice from a specialist. When the
unit is switched on for the first time, some smell may occur. This is normal
and will disappear after a while.
– The unit contains voltage carrying parts. Therefore do NOT open the housing.
– Do not place metal objects or pour liquids into the unit This may cause
electrical shock and malfunction.
– Do not place the unit near heat sources such as radiators, etc. Do not place
the unit on a vibrating surface. Do not cover the ventilation holes.
– The unit is not suitable for continuous use.
– Be careful with the mains lead and do not damage it. A faulty or damaged
mains lead can cause electrical shock and malfunction.
– When unplugging the unit from a mains outlet, always pull the plug, never
the lead.
– Do not plug or unplug the unit with wet hands.
– If the plug and/or the mains lead are damaged, they need to be replaced by a
qualified technician.
– If the unit is damaged to such an extent that internal parts are visible, do
NOT plug the unit into a mains outlet and DO NOT switch the unit on. Contact
your dealer.
– To avoid fire and shock hazards, do not expose the unit to rain and
moisture.
– All repairs should be carried out by a qualified technician only.
– Connect the unit to an earthed mains outlet (220240Vac/50Hz) protected by a
10-16A fuse.
-During a thunderstorm or if the unit will not be used for a longer period of time, unplug it from the mains. The rule is: Unplug it from the mains when not in use.
– If the unit has not been used for a longer period of time, condensation may
occur. Let the unit reach room temperature before you switch it on.
– Never use the unit in humid rooms or outdoors.
– To prevent accidents in companies, you must follow the application
guidelines and follow the instructions.
– Do not repeatedly switch the fixture on and off. This shortens the lifetime.
– Keep the unit out of the reach of children. Do not leave the unit
unattended.
– Do not use cleaning sprays to clean switches. The residues of these sprays
cause deposits of dust and grease. In case of malfunction, always seek advice
from a specialist.
– Do not force the controls.
– This unit is with a speaker inside which can cause a magnetic field. Keep
this unit at least 60cm away from the computer or TV.
– If this product has a built-in lead-acid rechargeable battery. Please
recharge the battery every 3 months if you are not going to use the product
for a long period of time. Otherwise, the battery may be permanently damaged.
– If the battery is damaged please replace it with a battery of the same
specifications. And dispose of the damaged battery environment friendly.
– If the unit has fallen, always have it checked by a qualified technician
before you switch the unit on again.
– Do not use chemicals to clean the unit. They damage the varnish. Only clean
the unit with a dry cloth.
– Keep away from electronic equipment that may cause interference.
– Only use original spares for repairs, otherwise serious damage and/or
dangerous radiation may occur.
– Switch the unit off prior to unplugging it from the mains and/or other
equipment. Unplug all leads and cables prior to moving the unit.
– Make sure that the mains lead cannot be damaged when people walk on it.
Check the mains lead before every use for damages and faults!
– The mains voltage is 220-240Vac/50Hz. Check if the power outlet matches. If
you travel, make sure that the mains voltage of the country is suitable for
this unit.
– Keep the original packing material so that you can transport the unit in
safe conditions.
This mark attracts the attention of the user to high voltages that are present
inside the housing and that are of sufficient magnitude to cause a shock
hazard.
**This mark attracts the attention of the user to important instructions
that are contained in the manual and that he should read and adhere to.
The unit has been certified CE. It is prohibited to make any changes to the
unit. They would invalidate the CE certificate and their guarantee!
NOTE: To make sure that the unit will function normally, it must be used
in rooms with a temperature between 5°C/41°F and 35°C/95°F.
**Electric products must not be put into household waste. Please bring them
to a recycling center. Ask your local authorities or your dealer about the way
to proceed. The specifications are typical. The actual values can slightly
change from one unit to the other. Specifications can be changed without prior
notice.
Do not attempt to make any repairs yourself. This would invalidate your
warranty. Do not make any changes to the unit. This would also invalidate your
warranty. The warranty is not applicable in case of accidents or damages
caused by inappropriate use or disrespect of the warnings contained in this
manual. Power Dynamics cannot be held responsible for personal injuries caused
by the disrespect of the safety recommendations and warnings. This is also
applicable to all damages in whatever form.
UNPACKING INSTRUCTION
CAUTION! Immediately upon receiving the product, carefully unpack the
carton, check the contents to ensure that all parts are present, and have been
received in good condition. Notify the shipper immediately and retain the
packing material for inspection if any parts appear damaged from shipping or
the package itself shows signs of mishandling. Save the package and all
packing materials. In the event that the product must be returned to the
factory, it is important that the product be returned to the original factory
box and packed.
If the device has been exposed to drastic temperature fluctuation (e.g. after
transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched
off until it has reached room temperature.
MOUNTING THE VOLUME CONTROL
The volume control is not designed to be mounted in a standard electrical wall
box. Use the wall box that comes included in the package. The provided wall
box is designed to accommodate the volume control with the needed 49mm
mounting depth.
Select a location that is within reach of the speaker wires and easy to reach
when wanting to operate the volume control. Measure accurately before
initiating the cutting/sawing/drilling process!
Warning: Do not mount the volume control directly on a wall. Use the
provided wall box!
CONNECTIONS
-
Connect the speaker cable to the volume control:
A. Strip 6mm of insulation from the end of each cable.
B. Tightly twist the wires in each cable until there are no frayed ends.
C. Insert the 2-conductor speaker cables from the amplifier into the input terminal.
D. Insert the 2-conductor speaker cables from the first speaker into the output terminal. -
Connect additional speakers in parallel.
-
Make sure that all connections between your amplifier and the volume control, and between the volume control and each speaker, are in “phase”: (+) to (+) and (-) to (-).
-
Turn the volume knob to the “off” position (counterclockwise to “0”).
-
Screw the box into place.
-
Put on faceplate and screw in place using the supplied screws.
TECHNICAL SPECIFICATION
Impedance: 100V
Frequency response: 35Hz – 20kHz
Mounting depth: 49mm
Dimensions (L x W x H): 114 x 70 x 71mm
Weight (kg): 0,35
The specifications are typical. The actual values can slightly change from one
unit to the other. Specifications can be changed without prior notice.
The products referred to in this manual conform to the European Community
Directives to which they are subject:
- Low Voltage (LVD) 2014/35/EU
- Electromagnetic Compatibility (EMC) 2014/30/EU
- Restriction of Hazardous Substances (RoHS) 2011/65/EU
Specifications and design are subject to change without prior notice.
www.tronios.com
Copyright © 2021 by Tronios The Netherlands
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>