DOMO DO636K Electric Back and Neck Blanket Instruction Manual
- October 27, 2023
- DOMO
Table of Contents
DOMO DO636K Electric Back and Neck Blanket Instruction Manual
SAFETY INSTRUCTIONS
When using electrical appliances, basic safety precautions should always be taken, including the following:
- Read all instructions carefully. Keep this manual for future reference.
- Make sure all packaging materials and promotional stickers have been removed before using the appliance for the first time. Make sure children cannot play with the packaging materials.
- This appliance is intended to be used in household and similar applications such as:
- staff kitchen areas in shops, offices and other working environments;
- farm houses;
- by clients in hotels, motels and other residential type environments;
- bed and breakfast type environments.
- Children should be supervised to ensure that they do not play with the appliance.
- This appliance can be used by children aged from 16 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children unless they are older than 16 and supervised.
- Keep the appliance and its cord out of reach of children younger than 16 years.
- All repairs should be carried out by the manufacturer or its aftersales service.
- Any injury or damage caused by failure to comply with these rules are at your own risk. Neither the manufacturer, importer, or the supplier may be held liable.
ELECTRICAL WARNINGS
-
In order to avoid a hazard this appliance must not be supplied through an external switching device, such as a timer or a separate remote control, or connected to a circuit that is regularly switched on and off by the utility.
-
The appliance must be disconnected from its power source when not in use, during service and when replacing parts. Allow to cool before putting on or taking off parts, and before cleaning the appliance.
To disconnect, turn controls to “OFF” or “0” position, then remove the plug from the wall. Never pull the cord or appliance to remove the plug from the socket. -
Check carefully that the voltage and frequency of the power net match the indications on the rating label of the appliance.
-
The plug must be plugged into an appropriate outlet that is installed and grounded in accordance with all local standards and requirements.
-
Do not let the power supply cord hang over the edge of a counter, or touch hot surfaces.
-
Keep the power cord away from hot parts and don’t cover the appliance.
-
Unwrap the cord completely to prevent overheating of the cord. Do not allow the power cord supply to run underneath or around the unit.
-
The appliance may not be used with an extension lead or a multiple socket.
-
Do not operate this appliance with a damaged cord or plug or in the event the appliance malfunctions or has been damaged in any manner. Return the appliance to the DOMO Service Department or its service agent for examination, repair, or electrical or mechanical adjustment. Do not try to repair the appliance yourself.
INSTALLATION
- Do not place near flammable materials, gases or explosives.
- Do not use or store this appliance outdoors.
- Always use the appliance on a steady, dry and level surface.
- Never place this appliance near a gas stove or electrical stove or in a place where it may come into contact with a warm appliance.
USE
- Do not use this appliance for other than intended use.
- Only use the appliance for domestic use. The manufacturer cannot be held responsible for accidents that result from improper use of the appliance or not following the instructions described in this manual.
- Never leave the appliance unattended while it is functioning.
- Do not operate the appliance with wet hands.
- The use of accessories that are not recommended or sold by the manufacturer can cause fire, electrical shock or injuries. Only use the utensils delivered with the appliance.
CLEANING AND MAINTENANCE
- To protect against electrical shock or burns, do not immerse unit, cord, or plug in water or other liquid.
- Failure to maintain this appliance in a clean condition could adversely affect the life of the appliance and possibly result in a hazardous situation.
PRODUCT-SPECIFIC WARNINGS
- Wrap the cord up completely to prevent it from overheating.
- Never touch the device with wet or damp hands.
- Do not use needles, safety pins, or other sharp objects on the device as these will damage the wiring.
- While the device is switched on:
- No large or heavy object may be placed on top of it.
- No source of heat (e.g. hot-water bottles, bed warmers, heating pads) may be placed on top of it.
- Avoid letting animals lie on the device.
- The electric and magnetic fields emitted by this electrical product can interfere with the operation of a pacemaker under certain circumstances. Therefore, contact your doctor and the manufacturer of your pacemaker before using this product.
- The device is not intended for use in hospitals.
- The device must not be used by people who are insensitive to heat or who are unable to react should the device start to overheat.
- The cord and control panel of the device may present a risk of suffocation, strangulation, tripping, or stumbling if not laid away neatly. The user must ensure that the attachments and the cord are always in a safe position.
- The device may only be operated using the control panel supplied.
- Always allow the device to cool down before folding it up and storing it away.
- Do not crease the device by placing objects on top of it when stored.
- Do not use the device when it is still wet. The device must be completely dry before use.
- In case of long-term use, e.g. if the user falls asleep, it is recommended to set the device to setting 1.
- Unplug the device and allow it to cool down for at least 10 minutes before cleaning.
- The device can be washed by hand.
Never use the appliance when folded or bent
Do not stick pins or other sharp objects into the appliance
Not suitable for children under 3 years of age
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
PARTS
- Neck and back warmer
- Cable connection
- Neck fastening
- Waist fastening
- Control panel
- On/off button
- Increase heat setting
- Decrease heat setting
- Display
BEFORE THE FIRST USE
- Remove all packaging materials and any promotional stickers.
- Never use the device when folded, bent, turned down, and/or tucked in.
- Do not place artificial heat sources, or heavy and/or angular objects on the device.
- The device is equipped with overheating protection. This protection prevents the device from overheating across its entire surface by automatically switching off the power in the event of a malfunction. Please note that the device may not be used afterwards for safety reasons and must be returned to your retailer.
- There may be a slight odour from the device when it is used for the first time. This is normal. It is recommended that the room be ventilated briefly after the first use.
USE
-
Click the cable into the cable connector on the neck and back warmer and plug the other end into the electrical socket.
-
Lay the neck and back warmer over your shoulders, close the neck fastener using the snaps, and tie the belt around your waist. Make sure that the cable connector is located on the outside of the neck and back warmer.
-
Press the on/off button to switch on the appliance. “1” will appear on the display.
-
Then press the button to increase the heat setting. Each press of the button will increase the temperature. Use the button to lower the heat setting to decrease the temperature again. You can choose between 9 heat settings (1-9). We recommend starting on a low setting and gradually increasing it. The neck and back warmer will heat up quickly. The selected heat setting is shown on the display.
-
The appliance will switch off automatically after 1.5 hours. This is a set safety measure.
-
Let the appliance cool down for 10 minutes before turning it on again.
-
Press the on/off button if you want to disconnect the appliance. Then unplug the appliance.
ATTENTION!
-
Prolonged use on a high temperature setting may cause burns on a sensitive skin.
-
Check if the temperature is pleasant with the top of your hand. This zone is more sensitive than the palm of the hand.
-
If you use the appliance for several hours at the highest setting, the appliance could overheat.
CLEANING AND MAINTENANCE
-
Let the appliance cool down completely before cleaning it. Remove the connection plug. Always remove the plug from the electrical socket before cleaning.
-
The neck and back warmer can then be washed by hand. Wash the neck and back warmer using lukewarm water and a mild liquid detergent. Gently wring out any excess water. Rinse with clean water to remove all the detergent. Washing it too frequently can lead to colour changes or wear. So wash the neck and back warmer only when absolutely necessary.
-
Small stains can be cleaned with a cloth or damp sponge, if necessary with a liquid mild washing detergent.
-
Please note that the device must not be dry-cleaned.
-
Then let it air dry. Never dry in a tumble dryer, in the sun, or on a heater. Do not use clothes pegs.
Instead, drape the device over a drying rack. -
Never switch the device on to dry it faster.
-
Store the appliance in a dry place. Make sure the appliance is rolled up properly. Do not fold the appliance.
Washing symbol | Washing symbol explanation |
---|---|
Hand wash – max. water temperature of 30°C | |
Do not iron | |
Do not bleach | |
Not suitable for tumble dryer | |
Not suitable for dry cleaning |
STORING THE DEVICE
If you do not use the device for a longer period of time, we recommend that you store it in its original packaging in a dry environment and without placing anything heavy on top of it. Allow the device to cool down before storing it.
PROBLEMS AND SOLUTIONS
Problem | Solution |
---|---|
The appliance does not work. |
- Make sure the connection plug has been connected correctly.
- Check if the appliance works if you use another socket.
The appliance has been stopped working.|
- After 1.5 h, the appliance shuts off automatically. Let the appliance cool down for 10 min. and press again the on/off button.
“F” flashes on the display.|
-
Did you first insert the plug into the socket and then insert the connector plug into the device
You must always insert the connector plug first, and then plug the other end into the electrical socket. -
Did the connector plug accidentally come off while using the device? Remove the plug from the electrical socket first, then reattach the connector plug to the device, and then plug the cable back in.
The appliance does not heat enough.|
- After +/- 15 min. the appliance reaches the set temperature. Increase the temperature if necessary.
ENVIRONMENTAL GUIDELINES
This symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it must be brought to the applicable collection point for recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product.
The packaging is recyclable. Please treat the packaging ecologically.
WARRANTY
Dear client ,
All of our products are always submitted to a strict quality control before
they are sold to you.
Should you nevertheless experience problems with your device, we sincerely
regret this.
In that case, we kindly request you to contact our customer service.
Our staff will gladly assist you.
+32 14 21 71 91 info@linea2000.be
Monday – Thursday: 8.30 – 12.00 and 13.00 – 17.00
Friday: 8.30 – 12.00 and 13.00 – 16.30
This appliance has a two year warranty period. During this period the
manufacturer is responsible for any failures that are the direct result of
construction failure. When these failures occur the appliance will be repaired
or replaced if necessary. The warranty will not be valid when the damage to
the appliance is caused by wrong use, not following the instructions or
repairs executed by a third party. The guarantee is issued with the original
till receipt. All parts, which are subject to wear, are excluded from the
warranty.
If your device breaks down within the 2-year warranty period, you can return
the device together with your receipt to the shop where you purchased it.
The guarantee on accessories and components that are liable to wear-and-tear
is only 6 months.
The guarantee and responsibility of the supplier and manufacturer lapse automatically in the following cases:
- If the instructions in this manual have not been followed.
- In case of incorrect connection, e.g., electrical voltage that is too high.
- In case of incorrect, rough or abnormal use.
- In case of insufficient or incorrect maintenance.
- In case of repairs or alterations to the device by the consumer or non authorised third parties.
- If the customer used parts or accessories that are not recommended or provided by the supplier / manufacturer.
ORDER the original Domo accessories and parts online at: webshop.domo-
elektro.be
or scan here:
LINEA 2000 BV – Dompel 9 – 2200 Herentals – Belgium – Tel: +32 14 21 71 91 – Fax: +32 14 21 54 63
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>